Bedienungsanleitung Gorenje HEC50EP (Seite 15 von 26) (Englisch)

512706

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

Instructions for use and connection

− meat probe temperature display (d4-6a);

− meat probe temperature setting display (end

of oven operation) (d4-6b);

− selection sensor value setting 4 (4a, 4b)

5 ON/OFF sensor; signal lamp (red) (5a);

blockage of operation display – activation by

simultaneous pressing of 1 and 2 for

approximately 5 seconds (d6).

General settings

• Sound signal volume

− When no other function is active it is possible

to set the sound signal volume by touching

the sensor (4b). The display (d4-6) indicates

symbols of 4 volume levels.

• Sound signal duration:

− oven operation period sound signal (d4-1),

end of oven operation (d4-2) and meat probe

(d4-3) last 7 minutes;

− alarm timer sound signal (d4-4) lasts 3

minutes

− After the expiry of indicated time the sound

signal goes off automatically.

• Each proper touch of sensor is

accompanied by a beep.

• Changing the value setting speed

The value setting speed is doubled after 5

seconds of continuous sensor pressing.

• Simultaneous pressing of (-) and (+)

sensors (3a/3b) ali (4a/4b)

Resets the settings to “0”, except for the

temperature setting display (d3-1) which is

changed to 30°C, and the end of operation

sensor (d4-2) which changes to indicate the

time of day.

In case the ON/OFF sensor (5) is not pressed

within 5 seconds, all settings are reset

automatically, except for the time of day and the

alarm timer.

In case of eventual power failure which is less

that 1 minute long, all settings remain

unchanged and the oven resumes normal

operation (if activated).

(1)

(1a)

(2a)

(2)

(3a) (4a)

(5a)

(3b) (4b) (5)

(d4-3)

(d3-1)

(4)

(d6)

(d1) (d2)

(d4-6)

(d4-6a) (d4-6b)

(d4-5)

(d4-1)

(d4-4)(d4-2)

(d3-2)

Use of oven

Alternatives with the oven on:

Changing or setting the oven temperature (d3-1)

• Changing or setting oven operation time (d4-1)

Changing or setting end of oven operation (d4-2)

• Changing or setting meat probe temperature (d4-3)

if the meat probe is connected

Alternatives with the oven off:

• By using the food selection sensor (1) or mode

selection sensor (2) you may select the type of

food (1) or function mode (2), and you may

change or set the oven temperature (d3-1),

oven operation time (d4-1), end of oven

operation (d4-2), meat probe (if the type of food

or function mode had been selected before)

(d4-3) alarm timer (d4-4) and the time of day

(d4-5).

• changing or setting the alarm timer and the

current daily time (d4-4).

Setting the time of day

• After the appliance is connected to the mains

the display (d4-6) flashes »12.00« and the

symbol (d4-5).

• By touching the sensors (4a/4b) you may set

the exact daily time (approximately 5 seconds

after the setting is finished the symbol (d4-5)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gorenje HEC50EP Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info