633026
8
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
8
5.0 - DESCRIPTION OF THE ALARM SYSTEM ARMING/DISARMING
COMMAND WIRES
6.0 - DOORS LOCK/UNLOCK SIGNALS SELF-CODING
A - Using the RED/BROWN and RED/GREY wires you can arm and disarm the alarm
using the original vehicle remote, or door key lock.
- RED/BROWN WIRE: Connect to the vehicle wire that changes state when locking the doors.
- RED/GREY WIRE: Connect to the vehicle wire that changes state when unlocking the
doors.
Note: with this connection the YELLOW/BROWN and YELLOW/GREY wires have to be
connected to O/E vehicle earth.
B - Using the RED/BROWN, RED/GREY, YELLOW/BROWN and YELLOW/GREY wires,
the alarm will only arm and disarm using the original vehicle remote. YELLOW/BROWN
and YELLOW/GREY wire connections can be found in the vehicle technical guides
supplied by GT.
- YELLOW/BROWN WIRE: This wire has to be connected to the vehicle’s locking wire which
is only present when the door lock is being operated by the original vehicle remote.
- YELLOW/GREY WIRE: This wire has to be connected to the vehicle’s unlocking wire which
is only present when the door lock is being operated by the original vehicle remote.
WARNING:
- Ensure that the RED/BROWN, the YELLOW/BROWN, the RED/GREY and the YELLOW/
GREY wires are correctly connected (as indicated in the GT vehicle installation guides
or following the DESCRIPTION OF THE ALARM SYSTEM ARMING/DISARMING
COMMAND WIRES section), the ignition key must be in off and the alarm disarmed.
1- Earth the GREEN/YELLOW wire until the alarm system will emit a long acoustic signal and
the LED BUTTON starts to flash.
2 - During the next 10 seconds disconnect and then reconnect the earth to the GREEN/
YELLOW wire.
Note: after 10 seconds the alarm system will emit 3 visual (indicators)/acoustic signals and
automatically start the RAPID TEST procedure.
3 - At this point the system will emit 6 visual (indicators) /acoustic signals to indicate that it is
in condition to SELF-CODE THE DOORS LOCK (arming) AND UNLOCK (disarming)
SIGNALS; when the LED BUTTON starts flashing you have 2 minutes to carry out the points
4, 5 and 6.
4 - Make sure that all the doors and the boot and bonnet closed.
5 - Lock the vehicle using the original remote control, after a couple of seconds the alarm will
emit 1 visual (indicators)/acoustic signal and the doors will lock.
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für GT 800-2 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info