683782

Hako Scrubmaster B140R Seite 6

6
Zoom out
Zoom in
Vorherige Seite
1/38
Nächste Seite
Method of operation
of Hakomatic B 910
A squeegee and suitable brushes or
pads are required for wet cleaning of
hard floorings.
The rotating brushes scrub the floor
thoroughly, removing the dirt by
means of suds, thus cleaning the
floor. The soiled water is drawn in
during the same cycle by means of
the squeegee. This way the floor can
be stepped on immediately after-
wards; it is dry and clean.
Useful advice for perfect work
Prior to wet cleaning it is necessary to
sweep the floor. The Hakomatic B 910
carries out this work if equipped with
the optional pre-sweeper (accesso-
ries).This way, not only the cleaning
efficiency is improved, but wear of the
machine will be substantially reduced
at the same time.
If floors are particularly dirty or if wax
has to be removed (basic cleaning),
the floor should be treated twice.
During the first cycle, the floor is
scrubbed with a cleaning agent
se.lected according to the degree of
dirt encountered, the vacuum system
remaining turned off and the squee-
gee remaining lifted.
Allow the cleaning agent to act on the
floor for approx. 5 or 10 minutes, com-
plying with the manufacturer’s instruc-
tions, then scrub the floor once again
while the vacuum system is turned on
and the squeegee is lowered.
How to take the
machine into operation
Assembly
When being supplied to you, the
Hakomatic is packed in a cardboard
box. The floor consists of a wooden
platform where the machine is fixed
by means of plastic straps.
Open the box from its bottom side
and remove it by pulling upwards.
After detaching the plastic straps, you
now can take the machine from the
platform
Installation of brushes
Refer to paragraph ”Installation/Re-
moval of brushes” on page 54.
Installation of squeegee
Refer to paragraph ”Installation of
squeegee” on page 56.
Note: For ease of compliance with the
appropriate safety regulations, we re-
commend to use the above-mentioned
batteries. Batteries and charger units
are matched; therefore only use the
batteries and charger units specified
by us in order to comply with the pro-
visions for safety.
We can grant full warranty only if those
units are used.
Whenever working on the electrical
system, disconnect the battery plug.
The seat hood has to be opened
during the charging procedure to pre-
clude formation of an ignitable gas
mixture (oxyhydrogen).
38
Method of operation
of Hakomatic B 910
A squeegee and suitable brushes or
pads are required for wet cleaning of
hard floorings.
The rotating brushes scrub the floor
thoroughly, removing the dirt by
means of suds, thus cleaning the
floor. The soiled water is drawn in
during the same cycle by means of
the squeegee. This way the floor can
be stepped on immediately after-
wards; it is dry and clean.
Useful advice for perfect work
Prior to wet cleaning it is necessary to
sweep the floor. The Hakomatic B 910
carries out this work if equipped with
the optional pre-sweeper (accesso-
ries).This way, not only the cleaning
efficiency is improved, but wear of the
machine will be substantially reduced
at the same time.
If floors are particularly dirty or if wax
has to be removed (basic cleaning),
the floor should be treated twice.
During the first cycle, the floor is
scrubbed with a cleaning agent
se.lected according to the degree of
dirt encountered, the vacuum system
remaining turned off and the squee-
gee remaining lifted.
Allow the cleaning agent to act on the
floor for approx. 5 or 10 minutes, com-
plying with the manufacturer’s instruc-
tions, then scrub the floor once again
while the vacuum system is turned on
and the squeegee is lowered.
How to take the
machine into operation
Assembly
When being supplied to you, the
Hakomatic is packed in a cardboard
box. The floor consists of a wooden
platform where the machine is fixed
by means of plastic straps.
Open the box from its bottom side
and remove it by pulling upwards.
After detaching the plastic straps, you
now can take the machine from the
platform
Installation of brushes
Refer to paragraph ”Installation/Re-
moval of brushes” on page 54.
Installation of squeegee
Refer to paragraph ”Installation of
squeegee” on page 56.
Note: For ease of compliance with the
appropriate safety regulations, we re-
commend to use the above-mentioned
batteries. Batteries and charger units
are matched; therefore only use the
batteries and charger units specified
by us in order to comply with the pro-
visions for safety.
We can grant full warranty only if those
units are used.
Whenever working on the electrical
system, disconnect the battery plug.
The seat hood has to be opened
during the charging procedure to pre-
clude formation of an ignitable gas
mixture (oxyhydrogen).
38
Method of operation
of Hakomatic B 910
A squeegee and suitable brushes or
pads are required for wet cleaning of
hard floorings.
The rotating brushes scrub the floor
thoroughly, removing the dirt by
means of suds, thus cleaning the
floor. The soiled water is drawn in
during the same cycle by means of
the squeegee. This way the floor can
be stepped on immediately after-
wards; it is dry and clean.
Useful advice for perfect work
Prior to wet cleaning it is necessary to
sweep the floor. The Hakomatic B 910
carries out this work if equipped with
the optional pre-sweeper (accesso-
ries).This way, not only the cleaning
efficiency is improved, but wear of the
machine will be substantially reduced
at the same time.
If floors are particularly dirty or if wax
has to be removed (basic cleaning),
the floor should be treated twice.
During the first cycle, the floor is
scrubbed with a cleaning agent
se.lected according to the degree of
dirt encountered, the vacuum system
remaining turned off and the squee-
gee remaining lifted.
Allow the cleaning agent to act on the
floor for approx. 5 or 10 minutes, com-
plying with the manufacturer’s instruc-
tions, then scrub the floor once again
while the vacuum system is turned on
and the squeegee is lowered.
How to take the
machine into operation
Assembly
When being supplied to you, the
Hakomatic is packed in a cardboard
box. The floor consists of a wooden
platform where the machine is fixed
by means of plastic straps.
Open the box from its bottom side
and remove it by pulling upwards.
After detaching the plastic straps, you
now can take the machine from the
platform
Installation of brushes
Refer to paragraph ”Installation/Re-
moval of brushes” on page 54.
Installation of squeegee
Refer to paragraph ”Installation of
squeegee” on page 56.
Note: For ease of compliance with the
appropriate safety regulations, we re-
commend to use the above-mentioned
batteries. Batteries and charger units
are matched; therefore only use the
batteries and charger units specified
by us in order to comply with the pro-
visions for safety.
We can grant full warranty only if those
units are used.
Whenever working on the electrical
system, disconnect the battery plug.
The seat hood has to be opened
during the charging procedure to pre-
clude formation of an ignitable gas
mixture (oxyhydrogen).
38
Method of operation
of Hakomatic B 910
A squeegee and suitable brushes or
pads are required for wet cleaning of
hard floorings.
The rotating brushes scrub the floor
thoroughly, removing the dirt by
means of suds, thus cleaning the
floor. The soiled water is drawn in
during the same cycle by means of
the squeegee. This way the floor can
be stepped on immediately after-
wards; it is dry and clean.
Useful advice for perfect work
Prior to wet cleaning it is necessary to
sweep the floor. The Hakomatic B 910
carries out this work if equipped with
the optional pre-sweeper (accesso-
ries).This way, not only the cleaning
efficiency is improved, but wear of the
machine will be substantially reduced
at the same time.
If floors are particularly dirty or if wax
has to be removed (basic cleaning),
the floor should be treated twice.
During the first cycle, the floor is
scrubbed with a cleaning agent
se.lected according to the degree of
dirt encountered, the vacuum system
remaining turned off and the squee-
gee remaining lifted.
Allow the cleaning agent to act on the
floor for approx. 5 or 10 minutes, com-
plying with the manufacturer’s instruc-
tions, then scrub the floor once again
while the vacuum system is turned on
and the squeegee is lowered.
How to take the
machine into operation
Assembly
When being supplied to you, the
Hakomatic is packed in a cardboard
box. The floor consists of a wooden
platform where the machine is fixed
by means of plastic straps.
Open the box from its bottom side
and remove it by pulling upwards.
After detaching the plastic straps, you
now can take the machine from the
platform
Installation of brushes
Refer to paragraph ”Installation/Re-
moval of brushes” on page 54.
Installation of squeegee
Refer to paragraph ”Installation of
squeegee” on page 56.
Note: For ease of compliance with the
appropriate safety regulations, we re-
commend to use the above-mentioned
batteries. Batteries and charger units
are matched; therefore only use the
batteries and charger units specified
by us in order to comply with the pro-
visions for safety.
We can grant full warranty only if those
units are used.
Whenever working on the electrical
system, disconnect the battery plug.
The seat hood has to be opened
during the charging procedure to pre-
clude formation of an ignitable gas
mixture (oxyhydrogen).
38
Scrubmaster B140 R
The Scrubmaster B140 R
Scrubmaster is packed in a cardboard
… 6 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hako Scrubmaster B140R wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info