Bedienungsanleitung Harman Kardon AVR7200 (Seite 5 von 52) (Englisch)

502637

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

FRONT-PANEL CONTROLS

1 Main Power Switch: Press this button to apply

power to the AVR 7200. When the switch is pressed

in, the unit is placed in a Standby mode, as indicated

by the amber

Power Indicator 3 surrounding the

System Power Control 2. This button MUST be

pressed in to operate the unit. To turn the unit off and

prevent the use of the remote control, this switch

should be pressed until it pops out from the front

panel so that the word “OFF” may be read at the top

of the switch.

NOTE: This switch is normally left in the “ON” position.

2 System Power Control: When the Main Power

Switch

is “ON,” press this button to turn on the

AVR 7200; press it again to turn the unit off. Note that

the Power Indicator

surrounding the switch will

turn green when the unit is on.

3 Power Indicator: This LED will be lit in amber

when the unit is in the Standby mode to signal that the

unit is ready to be turned on. When the unit is in oper-

ation, the indicator will turn green.

4 Headphone Jack: This jack may be used to listen

to the AVR 7200’s output through a pair of headphones.

Be certain that the headphones have a standard

/4"

stereo phone plug. The main room speakers will

automatically be turned off when the headphone jack

is in use.

5 Tone Mode: This button allows you to remove the

tone controls (Treble, Bass and Balance) from the signal

path. The first press of the button displays a

TONE

message in the Main Information Display ˜.

If you wish to set the tone controls to “flat,” without any

treble or bass alteration, press the

‹

›

Selector

Buttons

)# so that TONE OUT appears in

the

Lower Display Line B.

6 Speaker Selector: Press this button to begin the

process of configuring the AVR 7200 for the type of

speakers it is being used with. For complete informa-

tion on configuring the speaker settings, see page 21.

7 Surround Mode Group Selector: Press this but-

ton to select the top-level group of surround modes.

Each press of the button will select a major mode

grouping in the following order:

Once the button is pressed so that the name of the

desired surround mode group appears in the on-screen

display and in the

Lower Display Line B, press the

Surround Mode Selector 8 to cycle through the

individual modes available. For example, press this but-

ton to select Dolby modes, and then press the

Surround Mode Selector 8 to choose from the var-

ious mode options.

1 Main Power Switch

2 System Power Control

3 Power Indicator

4 Headphone Jack

5 Tone Mode

6 Speaker Selector

7 Surround Mode Group Selector

8 Surround Mode Selector

9 Tuning Selector

)

‹

Button

! Tuner Band Selector

@ Set Button

›

Button

$ Preset Station Selector

% Input Source Selector

^ Tuner Mode Selector

& Optical 3 Digital Input

* Input/Output Status Indicator

( Coaxial 3 Digital Input/Output

Ó Video 4 Input/Output Jacks

Ô Bass Control

 Balance Control

Ò Treble Control

Ú Channel Adjust Selector

Û Delay Adjust Selector

Ù Digital Input Selector

ı Volume Control

ˆ Input Indicators

˜ Main Information Display

¯ Remote Sensor Window

˘ Surround Mode Indicators



(

8 ) $

FRONT-PANEL CONTROLS

FRONT-PANEL CONTROLS 55

Dolby Modes

DTS Digital Modes

VMAx Modes

DSP Modes

Stereo Modes

Logic 7 Modes

AVR 7200 OM 1/27/03 4:46 PM Page 5

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Harman Kardon AVR7200 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info