Bedienungsanleitung Hendi 225059 (Seite 6 von 36) (Englisch, Polnisch)

741835

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Connecting the power cable:

The terminal board is on the rear panel of the ap-

pliance. Open the terminal board cover by obtain-

ing leverage with a screwdriver on the two side ﬁ ns.

Loosen the cable gripper screw and allow the ca-

ble to pass through it. Arrange the conductors so

that the earth conductor is the last to detach from

its terminal if the cable goes into a state of faulty

traction. Connect the phase conductor to the ter-

minal marked with the letter “L”, the neutral

conductor to the terminal marked with the let-

ter “N” and the earth conductor to the terminal

marked with the symbol

Tighten the ring-nut of the cable gripper and close

the terminal board cover.

Tighten the cable gripper and re-ﬁ t the rear side-panel

of the appliance.

Any appliance must be connected to an equipoten-

tial system whose efﬁ ciency must ﬁ rst be checked

according to current legal regulations.

This connection must be made between differ-

ent appliances by using the appropriate terminal

marked

with the symbol . The equipotential con-

ductor must

have a minimum diameter of 2,5 mm

The equipotential terminal is at the rear of the ap-

pliance.

Safety thermal breaker

The appliance is supplied with a manually resetting

thermal breaker to protect against excessive, dan-

gerous temperatures which could be accidentally

generated inside. If it is tripped, the device cuts off

the power supply to the appliance.

The device is located on the back of the unit and is

identiﬁ ed by a suitable label. The reset button can

be activated after unscrewing the black plastic cov-

er and letting the oven cool down.

5. USE INSTRUCTIONS (FOR THE USER)

For ﬁ rst use, we advise you to let the appliance to

run load-free for 30/40 minutes at a temperature

of 200°C. In this way, any unpleasant smells due

to thermal insulation and residual work grease are

eliminated.

This appliance must be used solely for the purpose

for which it was expressly designed, i.e. cooking

foods in the oven. Any other use is considered un-

suitable.

The appliance can be used: for all oven cooking of

deserts, pizzas, meat, ﬁ sh, vegetables, as well as

for re-conditioning cooled and frozen foods.

When placing food in the cooking compartment,

leave a space of at least 40 mm between pans in

order not to over-obstruct air circulation.

Do not use pans with higher than necessary edges:

edges are barriers which prevent the circulation of

hot air (for cooking of bread and pastry; do not use

pans with borders higher than 20 mm, avoid that

products into the pan get in contact).

Warm up the oven before every cooking operation

(set a temperature 30°C higher than cooking tem-

perature) to obtain maximum uniformity. Do not

salt foods in the cooking compartment.

230V

L2 L1 N

400V / 2N

L2 L1

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hendi 225059 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info