Bedienungsanleitung Hendi 225264 (Seite 6 von 68) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Polnisch)

741249

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

1. Operation: SET TEMPERATURE

1.1 Fill the container with (hot) water and make sure

that the water will not come over the edge on

the inner mark (groove) of the water tank. Re-

member that placing food in the water will also

raise the water level – it should still not pass

aforementioned groove. Water should be ﬁlled

up to the Max Mark no matter the amount of

food you are going to put into the water bath for

cooking

1.2 Connect the power plug to a suitable electrical

power outlet

1.3 Press the ON/OFF Icon.

1.4 Then blue LED in the ON/OFF Icon is ON. The

upper Temperature display will show the last

SET TEMPERATURE. The lower display will

show the appliance is in standby mode (----).

NOTE! The appliance beeps once for a short time

1.5 Press INCREASE/DECREASE Icon, the lower dis-

play will show, the heating element is switched

ON. At this moment, The Temperature Display

will show the ACTUAL TEMPERATURE. The low-

er Timer Display will show the last set time.

1.6 Now, press the Temperature Icon, the upper dis-

play will show the previous SET TEMPERATURE.

Lower display will show °C for 1 ~ 2 seconds. And

then show the time.

1.7 Then, press the INCREASE/DECREASE Icon to

adjust the SET TEMPERATURE within this 1 ~ 2

Seconds. The SET TEMPERATURE range is 40°C

~ 90°C.

Press once for +0,1˚C / -0,1˚C.

Press and hold for +1,0°C / -1,0˚C.

1.8 When stop to press INCREASE/DECREASE Icon,

the SET TEMPERATURE will be stored automat-

ically.

1.9 The Temperature Icon will blink until the SET

TEMPERATURE is reached. After reaching the

SET TEMPERATURE, the Temperature Icon

lamp will turn off and a short beep sound will be

heard and keep stay of within a range of +0,5˚C

/ -0,5˚C. If the Actual Temperature over the SET

TEMPERATURE about 1°C, the Temperature

Display will show “H0t”.

NOTE!

If you don’t put water into the water bath and try to

switch on the power by step 1.3 to 1.7, the thermal

protection of the appliance will act to stop the pow-

er. The upper Temperature Display will show the E2.

The lower Timer Display will show ----. And long

beep sound will be heard. The user can only switch-

es OFF the appliance to stop this warning signal.

2. Operation: SET TIMER

2.1 During cooking, you can activate the TIMER

function.

2.2 Press TIME Icon to set the TIMER. The upper

display will show “t”. Then, press INCREASE/

DECREASE Icon within 1 ~ 2 seconds to set the

TIMER. Press once for + 5,0 min / - 5,0 min. And

the lower display will show the “SET TIMER”.

And start count down after few seconds.

2.3 The “:” will blink until 00:00 and “END” will be

blinked continuously. Two short beep sound will

be heard and the “Timer Icon” will also light off.

Note: When the TIMER ﬁnish counting, the pow-

er of the appliance doesn’t switch OFF. The wa-

ter tank will continue to operate and keep the

temperature stable.

2.4 You can also press Timer Icon to start count

down from 00:00 in ascending order by press-

ing the Timer Icon once for 2 ~ 3 seconds. Press

again to cancel this function.

NOTE!

Time in count down can be adjusted all time

• During Timer is counting, if the user presses the

Timer icon, Timer counting will be suspended and

shows the time left

• In this moment, the user can adjust the Timer val-

If during operation, water in the water bath has been

dry up, the thermal protection of the appliance will

act to stop the power. The upper Temperature Dis-

play will show the E2. The lower Timer Display will

show ----. And long beep sound will be heard. The

user can only switches OFF the appliance to stop

this warning signal.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hendi 225264 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info