Bedienungsanleitung Honda FG110 (Seite 7 von 18) (Englisch)

625322

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

ENGLISH

TILLER OPERATION

The tiller is designed to operate either with the drag bar installed for

depth control in the forward direction or with the drag bar removed for

cultivating.

Cultivating Without the Drag Bar

Cultivating can be accomplished by removing the drag bar and

repeatedly moving the tiller in a forward/reverse direction. This allows

the tines to dig in both directions.

Be aware that the tiller can be difficult to control without the drag bar

installed.

Narrow Cultivating

The two outer tines can be removed to give you a narrower cultivating

width. This width is approximately 127 mm. This gives you the ability

to get between very closely spaced plants.

To remove the two outer tines, pull the lock pin [1] out of the hole in

each end of the tine shaft. Slide the outside tine set off the tine shaft.

Secure the inner set of tines onto the tine shaft by placing the lock

pins in the inside set of lock pin holes.

Tilling With the Drag Bar Installed

1. Install the drag bar and set the tilling depth by moving the drag bar

up or down into one of 4 height positions (page 5).

The ideal height of the drag bar will depend on the type of soil

being tilled and soil conditions at the time of tilling. In general,

however, the drag bar should be adjusted so that the tiller is tilted

slightly backward.

2. Start the engine (page 6).

3. Tilt the tiller back until the tines

are off the ground. Squeeze

the throttle lever [1] to full

speed position (lever tight

against the grip).

4. Lower the front of the tiller until

the tines begin to dig into the

ground.

5. Lower the handlebar [2] slightly so the front of the tiller is raised

about 6 - 8°. To get the maximum advantage from the tiller, hold

the tiller at this angle while you are tilling the ground.

Operating Tips

• If the tiller tends to move forward rapidly, push down on the

handlebars [2] to allow the drag bar [3] to penetrate the soil and

slow the forward motion of the tiller. Continue to press down until

the tiller tines have dug to a desired depth that allows easy tiller

handling.

• If the tines dig in but the tiller will not move forward, ease up on the

handlebars and move the handlebars from side-to-side. If the tiller

still digs in, but will not move forward, raise the drag bar up one

hole.

• When turning, push down on the handlebars to bring the tiller’s

weight to the rear; this will make turning easier.

SERVICING YOUR TILLER

Proper maintenance is essential for safe, economical, and

trouble-free operation. It will also help reduce air pollution.

To help you properly care for your tiller, the following pages include a

maintenance schedule, routine inspection procedures, and simple

maintenance procedures using basic hand tools. Other service tasks

that are more difficult, or require special tools, are best handled by

professionals and are normally performed by a Honda technician or

other qualified mechanic.

The maintenance schedule applies to normal operating conditions. If

you operate your tiller under severe conditions, such as sustained

high-load or high-temperature operation, or use in unusually wet or

dusty conditions, consult your servicing dealer for recommendations

applicable to your individual needs and use.

Remember that an authorized Honda servicing dealer knows your

tiller best and is fully equipped to maintain and repair it.

To ensure the best quality and reliability, use only new, Honda

Genuine parts or their equivalents for repair and replacement.

[1]

B WARNING

Improper maintenance, or failure to correct a problem

before operation, can cause a malfunction in which you

can be seriously hurt or killed.

Always follow the inspection and maintenance

recommendations and schedules in this owner’s manual.

[1]

[3]

[2]

6 - 8°

FG110 EU.book Page 7 Thursday, January 22, 2009 8:14 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honda FG110 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Honda FG110

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info