Bedienungsanleitung Honda FG110 (Seite 9 von 18) (Englisch)

625322

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

ENGLISH

Engine Oil Change

Drain the used oil while the engine is warm. Warm oil drains quickly

and completely.

1. Place a suitable container below the engine to catch the used oil.

2. Remove the oil filler cap/dipstick.

3. Tip the tiller to drain the used oil through the oil filler opening. Allow

the used oil to drain completely.

Please dispose of used motor oil in a manner that is compatible

with the environment. We suggest you take used oil in a sealed

container to your local recycling center or service station for

reclamation. Do not throw it in the trash, pour it on the ground, or

pour it down a drain.

4. With the engine resting on the carrying handlebar on a level

surface, fill with the recommended oil to the edge of the oil filler

hole. Do not overfill.

5. Screw in the filler cap/dipstick securely.

Engine Oil Recommendations

Check the engine oil level with the engine stopped and the tiller on a

level surface.

Use 4-stroke motor oil that meets or exceeds the requirements for API

service category SJ or later. Always check the API SERVICE label on

the oil container to be sure it includes the letters SJ or later.

SAE 10W-30 is recommended for

general use (see table).

NOTICE

• Running the engine with a low oil

level can cause engine damage.

• Using nondetergent oil can

shorten the engine’s service life,

and using 2-stroke oil can damage

the engine.

Air Filter Check

1. Move the choke

lever [1] to the

CLOSED (

position to prevent

dirt from entering

the engine.

Squeeze together

the air cleaner

upper tab [3] at the

top of the air

cleaner cover [5] to

release it from its

catch, and then flip

the cover down to

remove it.

Check the air filter

[6] to be sure it is

clean, properly

oiled, and in good

condition.

4. If the air filter is dirty, clean it as described under Air Filter

Cleaning. Replace the air filter if it is damaged.

NOTICE

Operating the engine without an air filter, or with a damaged air

filter, will allow dirt to enter the engine, causing rapid engine wear.

This type of damage is not covered under warranty.

5. Align the air filter [6] with

the air cleaner base [2] as

shown. Reinstall the air

filter by locating the three

air cleaner base pegs into

the three air filter holes [7].

Slide the air filter over the

pegs until it is flush with

the air cleaner base.

NOTICE

An improperly installed air

filter will allow dirt to enter

the engine, causing rapid

engine wear. Make sure the air filter is properly installed and flush

with the air cleaner base before installing the air cleaner cover.

6. Reinstall the air cleaner cover [5] by hooking the two lower tabs [4]

on the bottom of the cover and snapping the upper tab [3] into

place.

AMBIENT TEMPERATURE



[3]

[2]

[1]

[4]

[6]

[5]

[7]

FG110 EU.book Page 9 Thursday, January 22, 2009 8:14 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honda FG110 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Honda FG110

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info