Bedienungsanleitung Honda FG110 (Seite 11 von 18) (Englisch)

625322

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

ENGLISH

Throttle Cable Inspection

Verify the throttle lever [1]

operates smoothly, releases

properly, and the throttle cable is

undamaged. If there is visible

damage, or if the throttle lever

does not operate smoothly or

release properly, take your tiller

to your authorized Honda

servicing dealer.

Carburetor Adjustment

A tachometer is required to

adjust the idle speed. If you

do not have one, take your

tiller to an authorized Honda

servicing dealer to perform

idle speed adjustment.

1. Start the engine outdoors,

and allow it to warm up to

normal operating

temperature.

2. Turn the throttle stop

screw [2] to obtain a

stable idle, below the

speed at which the tiller

tines begin to turn.

Standard Idle Speed:

3,100 ± 200 rpm

REFUELING

This engine is certified to operate on unleaded petrol with a research

octane rating of 91 or higher.

Refuel in a well-ventilated area with the engine stopped. If the engine

has been running, allow it to cool first. Never refuel the engine inside a

building where petrol fumes may reach flames or sparks.

You may use regular unleaded petrol containing no more than 10%

ethanol (E10) or 5% methanol by volume. In addition, methanol must

contain cosolvents and corrosion inhibitors. Use of fuels with content

of ethanol or methanol greater than shown above may cause starting

and/or performance problems. It may also damage metal, rubber, and

plastic parts of the fuel system. Engine damage or performance

problems that result from using a fuel with percentages of ethanol or

methanol greater than shown above are not covered by warranty.

If your equipment will be used on an infrequent or intermittent basis,

please refer to the fuel section of the STORAGE chapter (page 13) for

additional information regarding fuel deterioration.

Never use stale or contaminated petrol or an oil/petrol mixture. Avoid

getting dirt or water in the fuel tank.

1. To refuel, set the tiller

on level ground and

remove the fuel tank

cap.

2. Fill the tank with

petrol to the shoulder

of the filler neck [1].

Refuel carefully to

avoid spilling fuel. Do

not overfill.

3. After refueling,

tighten the fuel tank

cap securely.

Move the tiller at least 3

meters away from the fueling source and site before starting the

engine.

NOTICE

Fuel can damage paint and plastic. Be careful not to spill fuel when

filling your fuel tank. Damage caused by spilled fuel is not covered by

under warranty.

Fuel Tube Inspection

Check the clear fuel

return [1] and black fuel

supply [2] tubes, and

replace any tube that is

damaged, cracked, or

leaking.

Refer to the Honda shop

manual for tube

replacement instructions,

or take the tiller to an

authorized Honda

servicing dealer.

Fuel Filter and Fuel Tank Cleaning

1. Remove the fuel

tank cap.

2. Tip the tiller as

shown and empty

the fuel tank into an

approved petrol

container. Use a

funnel to avoid

spilling petrol.

B WARNING

Petrol is highly flammable and explosive.

You can be burned or seriously injured when handling fuel.

• Stop the engine and keep heat, sparks, and flame away.

• Handle fuel only outdoors.

• Wipe up spills immediately.

[1]

[2]

[1]

[2]

[1]

FG110 EU.book Page 11 Thursday, January 22, 2009 8:14 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honda FG110 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Honda FG110

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info