Bedienungsanleitung Honda GXV160K1 (Seite 12 von 16) (Englisch)

580732

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

12. TRANSPORTING

Keep the engine level when transporting to reduce the possibility

of fuel leakage.

Turn the fuel valve to OFF position (GXV160K1).

Throttle lever to stop position (GXV140).

13. STORAGE

Storage Preparation

Correct storage preparation is essential for keeping your engine

troublefree and looking good. The following steps will help to keep

rust and corrosion from impairing your engine’s function and

appearance, and will make the engine easier to start when you use

it again.

Cleaning

1.Clean all exterior surfaces.

2.Wash the engine with a garden hose or other low pressure

equipment. If the engine has been running, allow it to cool for at

least half an hour before spraying water on it. Never spray water

on a hot engine.

3.Start the engine, and let it run until it reaches normal operating

temperature to evaporate any remaining water.

4.Stop the engine, and allow it to cool.

Fuel

Gasoline will oxidize and deteriorate in storage. Deteriorated

gasoline will cause hard starting, and it leaves gum deposits that

clog the fuel system. If the gasoline in your engine deteriorates

during storage, you may need to have the carburetor, and other

fuel system components, serviced or replaced.

The length of time that gasoline can be left in your fuel tank and

carburetor without causing functional problems will vary with such

factors as gasoline blend, your storage temperatures, and

whether the fuel tank is partially or completed filled. The air in a

partially filled fuel tank promotes fuel deterioration.

Very warm storage temperatures accelerate fuel deterioration.

Fuel problems may occur within a few months, or even less if the

gasoline was not fresh when you filled the fuel tank.

Fuel system damage or engine performance problems resulting

from neglected storage preparation are not covered under

warranty.

You can extend fuel storage life by adding a gasoline stabilizer that

is formulated for that purpose, or you can avoid fuel deterioration

problems by draining the fuel tank and carburetor.

Adding a gasoline stabilizer to extend fuel storage life:

1.When adding a gasoline stabilizer, fill the fuel tank with fresh

gasoline. If only partially filled, air in the tank will promote fuel

deterioration during storage. If you keep a container of gasoline

for refueling, be sure that it contains only fresh gasoline.

2.Add gasoline stabilizer following manufacturers instructions.

3.After adding a gasoline stabilizer, run the engine outdoors for

10 minutes to be sure that treated gasoline has replaced the

untreated gasoline in the carburetor.

4.Stop the engine and turn the fuel valve to the OFF position.

Draining the fuel tank and carburetor

ATTENTION traits de coupes ancrés à un cadre automatique.

Positions : Gauche : 4.1 Haut : 3

2625

Gasoline is highly fflammble and explosive and you can be

burnt or seriously injured when refueling.

•

Stop engine and keep heat, sparks and flame away.

•

Refuel only outdoors.

•

Wipe up spills immediately.

! WARNING:

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honda GXV160K1 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Honda GXV160K1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info