Bedienungsanleitung Honda HRS536 (Seite 10 von 56) (Englisch, Französisch, Spanisch)

477990

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

10 ENGLISH

Fallen Leaves

If you want to mulch fallen leaves into your lawn, don't let the leaf

cover get too deep before you begin. For best results, start mulching

while grass still shows through the leaf cover. In places where fallen

leaves completely cover the grass, remove the leaves by raking.

Clogged Mower Deck

Before clearing a clogged mower deck, stop the engine and turn the

fuel valve to the OFF position. With the spark plug cap disconnected,

tilt the mower so the air cleaner side is up.

Clear a clogged deck with a stick, not your hands.

Mowing Patterns

Your Honda mower will work most efficiently if you use the following

mowing pattern as much as possible. Mower deck and equipment

design and the direction in which the blade rotates causes this

mowing pattern to give the best results.

Mulching

Use a counterclockwise mowing

pattern. If the lawn has an irregular

shape, or many obstacles, divide it

into sections where you can use

counterclockwise mowing patterns.

Side Discharge Mowing

Where possible, use the same

mowing pattern recommended for

mulching. If the lawn has an irregular

shape or many obstacles, divide it

into sections where clippings will be

discharged away from uncut areas.

This will prevent clippings from piling

up in the path of the mower.

TRANSPORTING

BEFORE LOADING

If the engine has been running, allow it to cool for at least 15 minutes

before loading the mower on the transport vehicle. A hot engine and

exhaust system can burn you and can ignite some materials.

Turn the fuel valve to the OFF [1] position. This will prevent carburetor

flooding and reduce the possibility of fuel leakage.

HANDLEBAR FOLDING

1. Loosen the lower

handlebar locking

knobs [1].

2. Spread the lower ends of

the handlebar struts [2]

to release the locating

pins. Fold handlebar

over mower.

When folding the

handlebar, be careful to

avoid kinking or pinching

the control cables.

LOADING AND UNLOADING

Position the mower so all four wheels are on the bed of the transport

vehicle. Tie the mower down with rope or straps, and block the

wheels. Keep the tie-down rope or straps away from the controls,

adjustment levers, cables, and the carburetor.

NOTICE

To prevent losing control of or damaging the mower, do not use the

drive system when going up or down a loading ramp.

To prevent damaging the drive system, do not engage the clutch

when the mower is rolling backwards.

1. Turn the fuel valve to the OFF position.

2. Use a suitable loading ramp. Adjust the loading ramp so that it is

inclined at an angle of less than 15°. If a loading ramp is not

available, two people should lift the mower on and off the transport

vehicle while keeping the mower level.

MULCHING AND SIDE

DISCHARGE PATTERN

[1]

[2]

15°

00X39VG36410.book Page 10 Monday, November 16, 2009 1:01 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honda HRS536 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Honda HRS536

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info