Bedienungsanleitung Husqvarna P 520D - 2015 (Seite 23 von 48) (Englisch)

595368

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

English – 23

STARTING AND STOPPING

Before starting

• Read the safety instructions and information concerning

the placement of controls and functions before starting.

• Perform daily maintenance before starting as set out in

the Maintenance schedule.

• Localise and mark stones and other ﬁxed objects to avoid

collision.

• Avoid mowing a wet lawn. The mowing results will then be

poorer.

• Start with a high cutting height and reduce down until the

required mowing results are obtained.

• The mowing result will be best with the highest permitted

engine speed, see technical data, (the blades rotate

rapidly) and low speed (the Mower moves slowly). If the

grass is not too high and thick, the driving speed can be

increased without noticeably depreciating the mowing

result.

• The best lawns are achieved if the grass is cut often.

Mowing becomes more uniform and the grass cuttings

become more evenly distributed over the surface. The

total time consumption is not greater since it is possible to

select a higher driving speed without inferior mowing

results.

• When the BioClip function is used, it is very important that

the mowing interval is not too long.

• Hose down the cutting unit with water underneath each

time it is used, avoid using a high pressure washer. The

cutting unit should then be put in the service position.

Start the engine

1 Ensure that the bypass valves are closed.

2 Apply the parking brake.

3 Stop the blades by pressing in the control for driving the

cutting unit.

The engine will not start unless the parking brake is on

and the cutting unit drive activated.

4 Move the throttle control to half throttle.

If the engine is cold move the choke lever backwards to its

end position.

5 Turn the ignition key to the ignition position and hold it

there until the indicator light on the instrument panel goes

out.

6 Turn the ignition key to the start position.

7 When the engine starts release the ignition key

immediately back to neutral position.

8 Set the required engine speed with the throttle control.

Let the engine run at moderate speed or half throttle for 3-

5 minutes before subjecting it to heavy load.

IMPORTANT!

The air intake grille in the engine cover must not be blocked

by, for example, clothing, leaves, grass or dirt. Impaired

cooling of the engine. Risk of major engine damage.

WARNING! Do not modify the machine’s

safety devices and check regularly that they

are working properly.

IMPORTANT! Do not run the starter for more than about 15

seconds at a time. If the engine does not start, wait about

15 seconds before trying again.

WARNING! Never run the engine indoors, in

enclosed or poorly ventilated areas. The

exhaust fumes contain toxic carbon

monoxide.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Husqvarna P 520D - 2015 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Husqvarna P 520D - 2015

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info