Bedienungsanleitung Husqvarna P 520D - 2015 (Seite 24 von 48) (Englisch)

595368

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

24 – English

STARTING AND STOPPING

Starting when cold

If the engine fails to start due to the cold, repeat ignition and

attempt to re-start. Start gas or ether must not be used.

For more information about winter fuel, please see 'Fuel

handling'.

Starting the engine with a weak

battery

If the battery is too weak to start the engine, it should be

recharged.

When jump leads are used for emergency starting, follow the

procedure below:

Connecting the jump leads

1 Connect each end of the red cable to the POSITIVE pole

(+) on each battery, exercise care not to short circuit any

of the ends against the chassis.

2 Connect one end of the black cable to the NEGATIVE pole

(-) on the fully charged battery.

3 Connect the other end of the black cable to a good

CHASSIS EARTH, away from the fuel tank and the

battery.

Remove the cables in the reverse order

• The BLACK cable is removed from the chassis and then

the fully charged battery.

• Finally the RED cable from both batteries.

Braking

Release the drive pedals. The machine slows and is stopped

by the drive system. Do not use the parking brake as the drive

brake.

Quicker braking is possible if you press down the drive pedal

for the opposite direction.

Stop the engine

Always park the machine on a level surface with the engine

OFF.

Preferably allow the engine to idle for a minute to obtain

normal working temperature before stopping it if it has been

working hard.

1 Stop the blades by pressing in the control for driving the

cutting unit.

2 Apply the parking brake by moving the handle downward.

3 Lift the cutting unit with the hydraulic lifting lever.

4 Move the throttle control to the MIN. position.

5 Turn the ignition key to ”OFF”-position.

IMPORTANT! At temperatures below 0 ° C, the machine

must be warmed up for at least 10 minutes for the hydraulic

oil and transmission to get hot. Otherwise there is a risk of

the transmission breaking down thereby reducing the

service life of the transmission.

WARNING! Lead-acid batteries produce

explosive gases. Avoid sparks, open ﬂames

and smoking close to batteries. Always wear

protective glasses in the vicinity of batteries.

IMPORTANT! Your Rider is equipped with a 12-volt system

with negative earth. The other vehicle must also have a 12-

volt system with negative earth. Do not use your Rider

battery to start other vehicles.

WARNING! Never connect the negative

terminal of the fully-charged battery to, or in

the vicinity of, the negative terminal of the

discharged battery. Hydrogen gas may be

present with risk of explosion.

IMPORTANT! Never use a boost charger/start booster.

Use only conventional battery chargers. Always disconnect

the charger before starting the engine. So called boost

chargers/start boosters must never be used. These will

often increase the voltage (instead of the current) to

generate the power needed to start the engine. This

increase in voltage will damage the electrical system.

WARNING! Never use the reverse pedal to

brake the machine without the cutting unit

mounted. Risk of the machine overturning.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Husqvarna P 520D - 2015 Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Husqvarna P 520D - 2015

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info