Bedienungsanleitung Hwam Classic 4 (Seite 22 von 36) (Englisch, Dänisch, Schwedisch, Norwegisch)

571921

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

fIttIng the loose Parts

Before you start using the stove, you must ensure that all loose parts are ﬁtted correctly.

Vertical cross-section of HWAM Classic 4 (Drawing A)

1. By-pass damper. Can tip freely when the by-pass lever is pulled.

2. Smoke shelf. Is placed on top of the side stones.

3. Ember / log guard. Is placed behind angles in both sides.

Mounting of the baking section

We recommend that the stove is connected to a top outlet in order to achieve the highest possible

temperatures in the baking section. Before mounting the baking section, the covers and the rings for

the cooking holes are removed, and the smoke outlet to the rear is closed. After this a new Ø5 mm

sealing (8) is placed down into the smoke outlet socket (drawing A1). At the same time a cushion (9)

made out of the stove kit delivered with the baking section is placed round in the edge of the coo-

king holes (drawing A2). Then the baking section (5) is placed on top of the stove so the smoke inlet

sockets of the baking section are standing down in the smoke outlet as well as in the cooking holes

on top of the stove. Chimney or smoke ﬂue (11) is connected, and the cooking holes are closed with

the cover plates coming from the cooking holes of the stove.

The function of the baking section

When the by-pass damper of the cooking section in pushed in, the hot smoke gas is conducted up

around the baking section, thus giving the maximum heat in the baking section. When the by-pass

damper (7) of the baking section is pulled completely out, the smoke gas is conducted behind the

baking section and directly out into the chimney, thus giving minimum heat in the baking section.

Consequently, the temperature in the baking section is regulated by opening the by-pass damper

more or less.

Valve in the baking section

In the baking section a valve is mounted that, when opened, is functioning as an extraction in the

cooking section when it is used.

Mounting of the wood magazine

The wood magazine (6) is placed where the stove is to stand, and the stove is placed on top of it. The

four guide pins on the wood magazine must catch the legs of the stove. If the stove tips a little in the

coupling between the stove and the wood magazine, this is adjusted by means of the two adjusting

screws (10) mounted at the back of the wood magazine.

Air damper in the front door (Drawing D)

The air damper in the front door regulates the rinsing air that keeps the glass free from soot. The

sliding damper should only be closed that much down that the rinsing air is still able to keep the

glass clean.

The rinsing air enters into the secondary air supply ensuring a good secondary combus-tion of the

smoke gases.

The glass in the door can only keep itself free from soot, if the chimney draft is sufﬁcient, the combu-

siton is optimal, and if the ﬁrewood is dry. At nominal chimney draft, half open will be suitable.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hwam Classic 4 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Hwam Classic 4

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info