Bedienungsanleitung Hwam Classic 4 (Seite 23 von 36) (Englisch, Dänisch, Schwedisch, Norwegisch)

571921

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

fIrIng manual – wood

Your ﬁrst heating session

When you light up for the ﬁrst time, you must do this very carefully as all materials must be heated

gradually. The door and the ashpan should be opened very carefully as there will otherwise be a risk

that the gaskets will stick to the lacquer. The coating on the stove will be cured the ﬁrst time the stove

is lit, and this may create an odour. Ensure for adequate ventilation.

D1. Firing (Drawing D)

1. The regulation rod (3) is pushed farthest to the right.

2. The sliding damper (2) in the door and the by-pass damper (1) are opened. Always pull out the

by-pass damper before opening the door.

3. Place 2 ﬁrelighters at the bottom of the stove. On top of this, place an amount of split kindling

wood equivalent to two logs (not more than 2 kg). Now light up. Keep door slightly open until

there is no more condensation (approx. 5 – 10 minutes). Shut the door. When the kindling wood

burns well, the regulating rod (3) is placed in middle position. Let the kindlings burn out till there

are no more visible ﬂames.

Important!

Do not open the ash pan when lighting up and always keep it closed when the stove is in use, if not

you can destroy the automatic control.

D2. Continous use

4. When there are no more visible yellow ﬂames, and a right ember is there, you can ﬁre again. A

right ember is when the whole bottom is covered, and the glows are lighting in a ring around the

shaking grate. Add 2 – 3 pieces of ﬁrewood (max 2 kg). At ﬁrst ﬁring, the sliding damper (2) in the

door is regulated down to half open.

5. When there are visible yellow ﬂames again, the regulating rod (3) of the automatic air ﬂow regu-

lating system is pushed back to middle position.

6. When in continuous use, no further regulation is necessary. This is done by the automatic air ﬂow

regulating system giving an even, constant burning. But if you want more heat, the regulating rod

is pushed further to the right, and if you want less heat, the regulating rod is pushed further to

the left. However, you may never close the primary air supply completely. When the stove is cold,

all dampers are closed.

fIrIng In general

Rapid or ﬁerce heat

Rapid or ﬁerce heat is obtained by burning many small pieces of wood.

Maximum amounts of fuel

The stove is approved for a maximum hourly burning of 2,0 kg wood or 1,6 kg briquettes

If these limits are exceeded, the stove will no longer be covered by the factory guarantee, and it may

also become damaged due to excessive heat.

Prolonged burning time

Prolong the burning time by burning a few (at least 2) very large pieces of wood while at the same

time closing the thermostatic control. The burning time can also be prolonged by setting the sliding

damper in the door to half open, though never more than would make the glass pane sooty.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hwam Classic 4 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Hwam Classic 4

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info