Bedienungsanleitung Hwam Classic 4 (Seite 24 von 36) (Englisch, Dänisch, Schwedisch, Norwegisch)

571921

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Insufﬁcient ﬁring

If the ﬁreproof materials in the combustion chamber are blackened after a ﬁre, then the stove is pol-

luting, and the automatic air ﬂow regulating system is malfunctioning. It will be necessary, therefore,

to open the thermostatic controller. It may also be necessary to burn more wood.

Cleaning the glass

We recommend wiping the glass after a ﬁre. This is best done using a paper towel.

Be aware that using fuels other than wood will cause soot to form on the glass!

Types of fuel

We recommend using birch or beechwood, which has been split and stored for at least one year

outdoors under cover. Wood stored indoors tends to become too dry and burn too quickly.

Briquettes give off a lot of heat. Certain types expand considerably, thus causing an uncontrollable

combustion.

Briquettes are very poor in gas.The air damper in the door can therefore be closed almost complet-

ely down. Furthermore, briquettes are good when terminating the ﬁring of the day, as they can burn

throughout the night.

The stove is EN-approved for ﬁring wood only. No particle board, lacquered, painted or

treated wood, plastics, or rubber may be burned.

maIntenance

Maintenance

Any maintenance of the stove should only be carried out when it is cold. Daily maintenance is limited

to vacuum cleaning the stove externally, using the soft brush attachment. You can also dust the stove

using a dry, soft cloth or brush, but on a cold stove only.

Once a year, the stove should be thoroughly serviced. The combustion chamber should be cleared of

ashes and soot. Door and ﬁttings should be lubricated using a copper-based grease.

Cleaning (Drawing A)

Prior to sweeping, dismount the smoke shelf, so that soot and ashes can be swept down into the

combustion chamber. After the sweeping of the chimney, clean the combustion chamber, and after-

wards remount the smoke plate. It is very important for the function of the stove that these are

mounted correctly.

• Remove one of the side stones and take out the smoke shelf (2).

• Open the by-pass damper (1). Ashes and soot from the sweeping will fall down partly in the

combustion chamber, partly lie on the by-pass damper from which it is easy to sweep the ashes

and the soot down into the combustion chamber.

• If the stove has a baking section, the by-pass (7) rod of the baking section is also pulled out prior

to sweeping.

• The cleaning, if any, of the sides of the baking section follows through the holes to the cooking

rings.

• Before cleaning the surrounding ﬂues of the stove, the side plates of the combustion chamber are

removed. This is done by taking the rear edge of the side plates and pull them towards the middle.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hwam Classic 4 Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Hwam Classic 4

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info