Bedienungsanleitung Inspire CR2.5 (Seite 21 von 28) (Englisch)

738436

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Page | 20

selected, the program will launch. If “Timer ON” was entered, “Set TIME” and “30:00” will begin to flash.

Adjust the time value, pressing ENTER to confirm and launch the program.

Program Launch A consistent heart rate signal is required for the Heart Rate programs to operate. If no signal is detected,

the NO HR SIGNAL banner will flash. If 30 seconds elapse without a heart rate signal, the program will

automatically end, and the Wake Mode will launch.

When the HR programs launch, the selected heart rate target (example: “HR target = 123 bpm”) will flash

in the 13x94 Brickyard Display. If a timer was selected, the timer will begin to count down from the entered

time value. If the timer was not added, the timer will count upward continuously until the program is

manually ended.

If the user’s pulse value ever varies more than 10%+/- from the selected target, the console will begin to

post instructional messages such as “HR too LOW” and “Speed UP!” If the user’s heart rate ever equals or

exceeds 100% of the calculated Maximum Heart Rate (MHR), warnings will post in the 13x94 Brickyard

Display and the speaker will sound every 10 seconds. As a safety measure, when operation at or above the

user’s calculated MHR, the program will automatically end.

End Program Heart Rate Programs will run continuously until either the user presses the STOP key or the value set for the

optional timer has elapsed.

MAINTENANCE

General

All Inspire models are engineered for years of operation. Let

noise be your first indication that a repair or adjustment is

required. Please discontinue use immediately and contact an

Authorized Service Technician or Fitness Dealer if an unusual

noise, scraping, knocking, grinding or vibration is detected.

Often, a minor issue will become a major repair if ignored

and use is continued.

Prior to each workout, confirm that all adjustment levers and

screws are tightened.

The CrossRower is manufactured of the most durable

materials available. The plastics are molded of strong and chemical-resistant ABS and PVC. The frame is produced of high-tensile steel and

protected with an industrial-grade, powder paint coating for the highest level of corrosion resistance. It is important to note however, that

perspiration can be extremely corrosive if allowed to accumulate on the machine. After training, always wipe down the unit with a mild soap

solution followed by a thorough drying with a clean towel. Positioning a small spray bottle and towel near the unit will help ensure that your

equipment looks new for many years.

NOTE: Perspiration is very corrosive and if allowed to remain on the machine, will cause discoloration, fading,

rust and odors. Unfortunately, these conditions are not covered under the Warranty Policy.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Inspire CR2.5 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info