Bedienungsanleitung Jotul F 520 (Seite 15 von 52) (Deutsch, Englisch, Holländisch)

657944

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

ENGLISH

ventilation. The wood stacks should be covered to protect the

logs from rain. The logs should be brought indoors during early

autumn and stacked/stored for use in the coming winter.

Be especially careful never to use the following materials

as fuel in your replace:

• Household rubbish, plastic bags, etc.

• Painted or impregnated timber (which is extremely toxic).

• Laminated wooden planks.

• Driftwood

These may harm the product and are also pollutants.

NB: Never use petrol, parafn, methylated spirit or similar

liquids to light the re. You may cause serious injury to

yourself and damage to the product.

Kindling (nely split wood):

Length: Max. 30 - 50 cm

Diameter: 6-10 cm

Quantity required each time: 3 pieces (0,6 - 0,8 kg) and

10 - 12 pieces with a total

weight about 1 kg

Wood (split wood):

Recommended length: 30 - 50 cm

Quantity required each time: 2 or 3 logs weighing 0.7 kg each,

i.e. 1.5-2.0 kg each time

Interval for adding wood: Approx. every 50 minutes

Quantity required each time: 2 - 3

Max. each time: 2,3 kg

Nominal heat output is achieved when the air vent is open

approx. 40% - 70%, and the ignition vent is open approx.

0% - 50%.

Initial lighting

• Open the air vent and ignition vent by pulling the handles

all the way out. (Use a glove or something similar to protect

your hand in case the handles are hot.).

Fig. 34

• Place two logs at the bottom of the burn chamber and pile

the kindling in layers.

• Finally, place a medium-sized log on the top of the pile.

• Place 2 or 3 briquettes or kindling sticks under the top layer

of kindling and light the re. NB: The maximum height of

the pile of the wood should be just below the horizontal

holes. The holes must not be covered.

• You can then regulate the rate of combustion to give the

heat you want by adjusting the air vent (g. 11).

• Check that the afterburning (secondary combustion) starts.

This is best indicated by yellow, ickering ames in front of

the holes under the bafe.

• If the air ow is normal you will be able to shut the door and

the re will take care of itself.

Adding rewood

Stoke the stove frequently but only add small amounts of fuel

at a time. If the stove is lled too full, the heat created may

cause extreme stress in the chimney. Add fuel to the re in

moderation. Avoid smouldering res as this produces the most

pollution. The re is best when it is burning well and the smoke

from the chimney is almost invisible.

5.1 Danger of overheating

The replace must never be used in a

manner that causes overheating

Overheating occurs when there is too much fuel and/or too

much air so that too much heat develops. A sure sign of

overheating is when parts of the replace glow red. If this

happens, reduce the air vent opening immediately.

Seek professional advice if you suspect that the chimney is

not drawing properly (too much/too little draught). For further

information, see «4.0 Installation» (Chimney and ue pipe).

5.2 Ash removal

• Only remove ash when the fireplace is cold.

• Use a scoop or similar to remove the ash through the door.

Always leave some ash as a protective layer on the bottom of

the fireplace.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Jotul F 520 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info