HELI 88
4.13 Programmable Mixing 1-3 (Function Mode), cont.
Programmable Mix #1 (Inhibited)
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
Press the DN and Select keys
simultaneously to access the
Function Mode List Display
Press either + or - key
to activate the Mix
function
Press either CH
key to program the
Master/Slave
channels, or to
move the cursor to
any of the 5 points
(L, 1, 2, 3,H)
Press to inhibit (INH)
the Mix function, or to
reset a point at the
cursor to 0
To Program Mixing #2
To Gyro Sensitivity
Adjustment function
Press SEL key to
move cursor after
mix has been
activated
To select the desired switch setting, press the SEL key twice to
move the cursor to the SW position on the LCD screen. Next,
press either the + or - keys to select the desired switch setting.
Mixing Point Adjustment
The 5-point Programmable Mixing Function found in
programmable mixes #1 and #2 allows you to manipulate one
or all of the point values to create a non-linear “curve” of the
second, or slave, servo output. Adjustment of this curve only
affects the second, or slave, channel and has no effect on the
servo output of the first, or master, channel. Points 1 and 3 are
inhibited, or inactive, until the user has input a value to the
particular mixing point.
To adjust the points, press the SEL key until the cursor is in line
with the “Point L” as indicated on the LCD display. Next, press
either CH key to select the point to be adjusted.
To change the value of the selected point, press either the + or -
key. The input value for the point being adjusted will be visible
under the “Point” portion of the LCD display. Both stick input and
servo output values will be shown at the lower left portion of the
LCD display.
Note: The servo output value will not be displayed on the screen
unless the operational switch selected is in the proper position to
activate the programmable mixing function.
Program Mix #2 Switch Settings
On On at all times
Hold On at throttle hold position
F-S12 On at flight mode stunt #1 and stunt #2 positions
Gear On at gear/inverted switch “on” position
