GLID 117
4.6 Aileron to Flap Mixing (Function Mode), cont.
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
SW OFF appears when the Flap Mixing is in
the middle or lower postition
Aileron to Flap Mixing Value (Range ± 125%)
Indicates current Mixing Switch activated:
Press the DN and Select keys
simultaneously to access the
Function Mode List Display
At rate, press to
increase/decrease
Mixing Value (± 125%)
At Switch, press to
change Switch
Selection
Press either CH
key to
manipulate the
arrow from
RATE to SW
At rate, press to
set Mixing value to
factory preset (0%)
At Switch, press to
set Switch to
factory preset (ON)
To Differential Aileron
Mixing function
To Elevator to Flap
Mixing function
ON: Always ON
MIX: Mixing Switch
FLP-D: ON when Flap Switch is in
lower position
FLP-U: ON when Flap Switch is in
upper position
4.7 Differential Aileron Mixing (Function Mode)
The XP8103 transmitter offers aileron differential. Differential
ailerons are used to tailor the flight control system to a particular
aircraft. Because the downward travel of the aileron creates
more drag than the upward travel, it is necessary to reduce the
amount of down travel for each aileron. This drag may very well
produce an adverse yawing tendency in your aircraft. As
adverse yaw is undesirable in most, if not all, R/C aircraft, it is
best to correct for this common flight tendency. Aileron
differential overcomes this yaw as it reduces the downward
travel of the ailerons.
In Function Mode, use the UP and DN keys to select Differential
Aileron Mixing and access by pressing the UP and DN keys
simultaneously.
Note: Differential may also be obtained by using the travel
adjust.
Indicates the
function being
selected:
↓
Rate
↓
SW
