The purpose of the Flap to Aileron Mixing Function is to allow
you to couple the ailerons to the flaps. This will enable you to
droop the aileron with the flaps to increase lift. If you should find
it necessary to redefine the neutral position of the ailerons, a
mixing offset is also provided. Note that the offset value for the
Flap to Aileron Mixing Function is also the same as the point
established for the flap to elevator mix, if utilized. When you
need the mix direction reversed, press the - key to increase
minus mixing.
In Function Mode, use the UP and DN keys to select Flap to
Aileron Mixing and access by pressing the UP and DN keys
simultaneously.
Selection of Operational Switch
Switches for Mixing Function ON/OFF position are listed in the
chart at right and can be accessed with the + or - keys. When
the applicable switch is in the OFF position, SW OFF flashes in
the left upper corner and increase or decrease mixing value is
not applicable. Press the CLR key to set ON.
Note that the offset value set by this function is the same as flap
to elevator mixing.
ON Always On
MIX Mixing Switch Is Forward
FLP-D Flap Switch is Down Position
F-U&D Flap Switch is Up or Down Position
4.8 Flap to Elevator Mixing (Function Mode), cont.
4.9 Flap to Aileron Mixing (Function Mode)
Flap Operating Direction
(D=Down, U=Up)
SW OFF appears when the Flap Mixing
is in the middle or lower position
Flap to Elevator Mixing Value (± 125%)
Indicates current Mixing Switch acitvated
Flap Offset Value
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
Press the DN and Select keys
simultaneously to access the
Function Mode List Display
At rate, press to
increase/decrease
Mixing Value (± 125%)
At switch, press to
change switch selection
Press to return the
mixing value to zero or
to return the active
mixing switch to ON
