Bedienungsanleitung Kenwood TS-590SG (Seite 44 von 96) (Englisch)

606692

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

7 COMMUNICATING AIDS

■ Checking CW Messages without Transmitting

1 Press [CW/FSK (REV)] until you select CW

mode.

• “CW” appears.

2 If Break-in is ON, press [VOX (LEV)] to turn

VOX OFF.

3 Press [CH1 (REC)], [CH2 (REC)], [CH3

(REC)], or [RX/4 (REC)] to select the channel

to be played back.

• The message is played back.

• When Menu No. 62 is “oFF”, press and

hold the current playback channel key to

repeatedly play back the message saved

to that key (a display such as “CP 1111”

appears for the channel key you pressed.).

To cancel the playback, press any channel

key or [CLR].

• To play back the messages stored in the

other channels in sequence, press the

corresponding channel keys during playback.

Up to 4 channels can be queued at the

same time. (Repeat playback, by pressing

and holding the keys, does not work during

consecutive message playback.)

• While playing back the messages, you can

also adjust the keyer speed by pressing

[KEY (DELAY)] and turning the MULTI/CH

control.

• To interrupt playback, press [CLR].

■

Transmitting CW Messages

Messages can be transmitted using Semi Break-in/

Full Break-in or manual TX/ RX switching.

1 Press [CW/FSK (REV)] until you select CW

mode.

• “CW” appears.

2 To use Semi Break-in/ Full Break-in, press

[VOX (LEV)].

• “ ” appears.

• If you are not using Semi Break-in/ Full

Break-in, press [SEND].

3 Press [CH1 (REC)], [CH2 (REC)], [CH3

(REC)], or [RX/4 (REC)] select the channel to

be played back.

• The message is played back and transmitted

automatically.

• To transmit the messages stored in the

other channels in sequence, press the

corresponding channel keys during playback.

Up to 4 channels can be queued at the

same time.

• While playing back the messages, you can

also adjust the keyer speed by pressing

[KEY (DELAY)] and turning the MULTI/CH

control.

• To cancel transmission, press [CLR].

■ Erasing a CW Message

1 Press and hold [CH1 (REC)], [CH2 (REC)],

[CH3 (REC)], or [RX/4 (REC)] to select the

message you want to erase.

• “CP n – –” appears, where “n” represents the

channel number.

2 To erase the CW message, press [CLR] while

continuing to hold the same key as in step 1

([CH1 (REC)], [CH2 (REC)], [CH3 (REC)], or

[RX/4 (REC)]).

• A beep sounds and the message is erased.

■

Changing the Inter-message Interval Time

For the message playback repeat, access Menu

No. 62 and select “on”. You can also change the

interval playback time of the message. Access

Menu No. 63 and select the time in the range of 0

to 60 seconds, in steps of 1 second.

Note: Menu Nos. 56 and 57 settings are shared with the

voice communication modes when the optional VGS-1 is

installed.

■ Changing the CW Sidetone Volume

Turning the AF control does not change the CW

sidetone playback volume. To change the CW

sidetone volume, access Menu No. 06 and select

“oFF”, or “1” to “20”. The default is “10”.

■ Insert Keying

If you operate a CW keyer manually while playing

back a recorded CW message, the transceiver

stops playing back the message. However, during

contests or regular QSOs, you may sometimes

want to insert a different number or message at a

certain point in the recorded message.

In this case, ﬁ rst record the CW message as

usual {page 35}, without the additional number or

message you want to insert. Then, access Menu

No. 39 and select “on”.

Now, if you operate a CW keyer while you play

back a recorded message, the transceiver pauses

the playback of the recorded message, instead of

stopping it. When you ﬁ nish sending the number or

message with the keyer, the transceiver resumes

playback of the message.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood TS-590SG Seite 44

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kenwood TS-590SG

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info