Bedienungsanleitung Krups f 893 (Seite 15 von 39) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

361252

Zoom out

Zoom in

Vorherige Seite

1/39

Nächste Seite

• Avoid contact with the hot parts of the

appliance by the cord or your hands

(hotplate for cups, capsule holder, steam

nozzle).

• Never immerse the appliance in water.

• Keep out of reach of children and do not

allow the cord to hang down.

• Follow the descaling instructions.

• Do not use the machine if it has been

damaged or if the cord is in poor condition.

• If the cord or any other specific element

becomes defective, these must be replaced

only by an approved Krups service centre.

You should never under any circumstances

open the appliance yourself. See Service

Agent leaflet for details.

• Check that the capsule holder is firmly in

place before making coffee and reset the

selector to

before loosening the capsule

holder.

Accessories

For best results, the appliance is delivered with

a set of accessories:

• 2 espresso cups

• 2 varieties of Nespresso coffee (2 x 10

capsules)

• 1 special hexagonal key (for dismantling the

capsule holder)

• 1 cleaning needle

For further information on the different

varieties of coffee available, or to order

capsules, you should contact your Nespresso

Club.

Setting-up the appliance

• Press on the lid of the water tank (1).

• The handle folds automatically. Fill the tank

with water (2).

You can also remove the water tank by raising

the handle (3).

Maximum capacity

1.1 L = 18 cups of espresso.

• Replace the water tank and press down

firmly so that the lower valve opens. Close

the lid again (4).

For a good cup of coffee, it is recommended

that you observe the following points:

• Empty the water tank after use.

• Change the water daily.

• Do not use mineral water or distilled water.

• Clean the water tank at least once a week.

Before using your espresso

maker for the first time

• Plug in the appliance.

• Rinse the heating system thoroughly by

running through two tanks of fresh water

(without a capsule or capsule holder).

• Introduce the empty capsule holder into the

fixing ring: to do this, position the handle at

about 90° to the left then turn; once

positioned, the handle should be facing you

or very slightly offset to the left (5).

• Place a container, as large as possible, under

the capsule holder. The function selector

must be in position

(6).

• Engage the on/off switch.The operating

indicator light (red) and the thermostat

indicator light (yellow) will come on (7).

• Once the yellow light goes out (which

means the machine is hot), set the function

selector to position

. Allow one tank of

water to run through the empty capsule

holder (8).

Preparing an espresso

• Fill the water tank with fresh water; to

preheat the capsule holder, leave it in place

in the fixing ring (but empty, with no

capsule)

• Turn the function selector to

. Switch on

the appliance. Both indicator lights will come

on (9).

• Wait until the temperature indicator light

has gone out (yellow).

Art. 893.PM6.5 21/01/04, 11:4415

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Krups f 893 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info