693399
26
Zoom out
Zoom in
Vorherige Seite
1/58
Nächste Seite
rev. 0/2018
lares 4.0 PROGRAMMING MANUAL
26
Wireless repeaters
duo (with external power supply and buffer battery).
The parameters available for duo repeaters are:
• Description: the name given to the device (e.g. first-floor repeater etc.)
• Serial number: this is the code which identifies the peripheral. Simply update the serial number to acquire the new
peripheral and to keep any previously saved settings if the device is being replaced.
Wireless I/O modules:
auxi wls
The parameters available for WLS auxi are:
• Description: the name given to the device (e.g. turning on the outdoor lights etc.)
• Serial number: six-digit code that identifies the device. Simply update the serial number to acquire the new peripheral
and to keep any previously saved settings if the device is being replaced.
• Type of outputs: the outputs can be programmed to operate in one of the following modes:
• Independent: the outputs associated with the device are completely independent.
• Switch: the two outputs on the device are treated as a single logic output.
The first one is normally open and the second one is normally closed.
This operating mode uses only one control panel output.
• Interlocked: in this mode, which is particularly useful for controlling the electric motors, the outputs
cannot be concomitantly active.
If the activation of an output is commanded while the other is active, the switching will be preceded
by the deactivation of both outputs for half a second.
Wireless sensors:
nanus poli
The parameters available for the nanus wireless magnetic contacts are:
• Description: the name given to the device (e.g. kitchen windows contact etc.).
• Serial number: this is the code which identifies the peripheral. Simply update the serial number to acquire the new
peripheral and to keep any previously saved settings if the device is being replaced.
• Supervision: maximum time between two consecutive transmissions.
poli
The parameters available for the poli wireless magnetic contacts are:
• Description: the name given to the device (e.g. entrance door contact etc.).
• Serial number: six-digit code that identifies the device. Simply update the serial number to acquire the new peripheral
and to keep any previously saved settings if the device is being replaced.
• Supervision: maximum time between two consecutive transmissions.
unum
The parameters available for the unum wireless detectors are:
• Description: the name given to the device (e.g. living room sensor etc.).
• Serial number: this is the code which identifies the peripheral. Simply update the serial number to acquire the new
peripheral and to keep any previously saved settings if the device is being replaced.
• Supervision: maximum time between two consecutive transmissions.
• Inhibition: this is the time (expressed in seconds) between the transmission of two alarms. To save the battery power,
the detector emits only one alarm during the set interval even if the events that generate the alarms are multiple.
Minimum configurable time: 5 seconds.
Maximum configurable time: 300 seconds.
26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Ksenia Lares 4.0 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info