812600
6
Zoom out
Zoom in
Vorherige Seite
1/36
Nächste Seite
MANUAL FOR USE AND MAINTENANCE
6 LSC 001 -UK- REV. 06
1.5
INSTALLATION REQUIREMENTS FOR THE USER
The machine has to be placed on a stable at
surface that can guarantee a safe position. Check
this important requirement, since the manufacturer
cannot be considered liable for any damage caused
by the instability of the appliance. While preparing
the systems, take into account that a hole is needed
in the bearing surface in order to make all electric and
water connections through the opening below where a
water softener will need to be tted, if recommended
by the installation engineer.
A hole of 10 x 10 cm is enough in the area (a) as
indicated in Pict. 1.
The machine needs a minimum clearance of:
- height cm. 60
- width cm. 40
- depth cm. 40
Between the water mains and the water inlet pipe of the appliance, there must be a tap to stop the water
ow if necessary (2 - Pict.1).
The water mains pressure must be within the range of 1 and 5 bar.
If this requirement is not met, please consult the manufacturer.
The appliance is supplied without a plug. It is supposed to be directly connected to the electric mains and
therefore, it is necessary to t a single-pole switch with contact opening of 3 mm or more beforehand,
according to the regulations in force (1 - Pict.1).
The drainpipe of the appliance must be directly connected to a suitable open drain siphon, previously
installed by the customer (3 - Pict.1).
Do not t the drain pipe into basins or buckets placed under the counter as this will increase the possibility
of forming dirt deposits and as a result, the spread of bacteria.
WARNING!
For appliances operating with gas, the gas supply tap must be tted in an easily accessible place
(4 - Pict.1), so as to be able to shut off the gas supply if necessary.
Regularly check the expiry date on the gas pipe connecting the system and the appliance and have
it replaced by the Service Centre before this date.
WARNING!
The appliance is supplied without water in the boiler. This is to prevent serious damage if the
appliance is exposed to low temperatures.
The appliance must only be supplied with cold drinking water.
1
2
3
x
Single pole switch with an opening of at least 3 mm between
contacts
Water supply tap
Drain siphon
Gas supply tap (if tted)
y
z*
*) Distance between the back of the appliance and
the wall.
min. 20 cm.
min. 40 cm.
min. 10 cm.
4
Y
X
4
1
a
2
3
X
001
1
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für La Spaziale RAPID wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info