812600
8
Zoom out
Zoom in
Vorherige Seite
1/36
Nächste Seite
MANUAL FOR USE AND MAINTENANCE
8 LSC 001 -UK- REV. 06
HEATING PHASE AND PRESET PHASE FOR OPERATION
(Range New - Rapid - Spazio - S3)
In the S5 1 GROUP range , turn the switch knob to position 2 (boiler heating element ON )
a) Fasten the lter holders (11) to the delivery groups (16).
b) Open the steam valves (5) (turning them anticlockwise) and leave them open; then move the steam
wands (8) over the grid (10).
c) Wait for steam to come out of the wands (8) (about 15 / 20 minutes) then close the steam valves (5)
(turning them clockwise).
d) Wait for the appliance to reach operating temperature, which can be seen on the pressure gauge (4)
on the appliance (1 bar pressure).
On the Seletron model it is possible to view the temperature in ° set during the installation phase
being reached on the display (33).
NOTE. The operating temperature is the boiler temperature during normal operation.
e) The appliance is ready for use.
HEATING PHASE AND PRESET PHASE FOR OPERATION
(Range S5 - Compact)
a) Fasten the lter holders (11) to the delivery groups (16).
b) Open the steam valves (5) (moving the lever upwards) and leave them open; then move the steam
wands (8) over the grid (10).
c) Wait for steam to come out of the wands (8) (about 15 / 20 minutes) then close the steam valves (5)
by moving the lever back to its original position.
d) Wait for the appliance to reach operating temperature, which can be seen on the pressure gauge (4) on
the appliance (1 bar pressure). For S5 range models, check the control panel (13) to make sure that the
temperature set at the time of installation, given in °C, has been reached. During the heating phases,
make sure that the symbols on the control panel (13) switch on in progression as the temperature rises.
The display will start to show this as soon as the temperature reaches 105 °C and will continue until
the appliance reaches its operating temperature (the set temperature symbols will go from ashing to
xed). Each time that the temperature drops to below the SET level, the symbol indicating the operating
temperature will start to ash (heating phase) until the set temperature is reached.
NOTE. The operating temperature is the boiler temperature during normal operation.
e) The appliance is ready for use.
COFFEE PREPARATION
a)
Remove a lter holder (11/a or 11/b according to whether 1 or 2 cups of coffee are required) from the
delivery
group (16).
b) Fill it with ground coffee, taking care not to leave any coffee powder on the top edge of the lter holder.
Press down the coffee with the special coffee tamper provided.
c) Firmly re-attach the lter holder to the group, without tightening it excessively.
d) Place one or two cups below the lter holder (according to whether it is for 1 or 2 cups of coffee).
e) Push the button (12) on the delivery group until the required of amount of coffee has been delivered,
then manually stop the delivery function by pressing the same button again.
f) For EK and Seletron models, it is sufcient to press any of the coffee delivery buttons (25-26-27-28)
with pre-set doses (set during installation) or alternatively, to use the manual delivery button (29).
NOTE. To stop coffee delivery earlier after using one of the buttons with pre-set doses, just press
the button (29) on the same touchpad (except for range Super 3000 Seletron model).
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für La Spaziale RAPID wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info