Bedienungsanleitung Lynx ONE (Seite 14 von 36) (Englisch)

586987

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Page 14

Record Dither – Enables the addition of dither during recording of 8-bit or 16-bit files

or when the record Volume Fader is set below full-scale. Dither is not added to the

signal for 24-bit or 32-bit files when the Volume Fader is at full-scale.

Play Dither – Enables the addition of dither during recording of 8-bit or 16-bit files or

when the record Volume Fader is set below full-scale. Dither is not added to the

signal for 24-bit or 32-bit files when the Volume Fader is at full-scale.

None - Dither is disabled. Volume processing utilizes rounding prior to truncation.

Triangular - Enables the addition of triangular probability density dither. This

type of dither is free of data-dependent noise modulation effects, but decreases

signal-to-noise ratio by 3 dB. Triangular is the preferred dither type in most

cases.

Shaped Triangular - Enables the addition of shaped triangular probability density

dither. This type of dither is essentially high-pass filtered triangular dither

that places most of the dither energy at higher frequencies making it less

audible to the human ear. Shaped triangular dither also decreases signal-to-

noise by 3 dB.

Rectangular - Enables the addition of rectangular probability density dither. This

type of dither decreases the signal-to-ratio by 1.25 dB (less than triangular),

but is less desirable because of its noise modulation effects.

Channel Lock – Volume controls for the Left and Right channels move together when

checked, and can be adjusted independently when unchecked. Holding the shift

key down while adjusting a volume control reverses the action of the channel

lock.

Show Options – Shows or hides the card options portion of the mixer window.

Always on Top – If checked, the Mixer window will be displayed on top of all

application windows. This allows the Mixer control to be seen even if another

application is the currently active window. If unchecked, the Mixer window can

be obscured by other applications.

Controls

Peak Meters – Displays the instantaneous level of the audio being recorded or played.

Peak meters do not reflect the level of input monitoring.

Volume Faders – Controls digital attenuation of the audio being recorded or played.

This control acts on the digital signals after A/D conversion and before D/A

conversion. With the volume fader at its maximum position, the vertical line within

the fader turns black, no volume calculation is performed and the audio stream is

unaltered. This is the recommended position for critical recording and mixdown

sessions in which the highest signal quality is required. Volume control processing

is done prior to peak meter readings causing the peak meters to reflect any volume

control changes. Since volume changes act on the digitally converted signals,

they have no affect on the analog full-scale input and output levels. This must be

done with Trim control. The volume control does not affect the input monitor

levels. When the volume fader is not at its maximum or minimum position, the

vertical line within the fader turns red to indicate that the volume control is active.

Mixer Reference

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Lynx ONE Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info