Bedienungsanleitung Marquant MPR51 (Seite 4 von 6) (Holländisch)

38776

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

Use Type 1 (normal) tapes only.

PLAYING BACK A TAPE

1 Set to TAPE.

2 Press STOP/EJECT to open the cassette

holder and insert a tape with the exposed side down and

the side to be played facing out.

3 Press PLAY to start play.

4 Turn VOLUME and BBS to adjust the sound.

STOP/EJECT - Stops play.

PAUSE - Pauses play. To resume play, press again.

F FWD/ REW - Fast forwards/rewinds. To stop

winding. press STOP/EJECT.

function switch

H TAPE OPERATION

G KARAOKE

RECORDING

1 Insert a tape with the side to be recorded facing out.

Wind the tape to the point where recording starts.

2 Get ready to record from the source.

To record from a CD: set function to CD and start play.

To record from the tuner: set function to RADIO and

tune to a station.

To record from built in MIC: set function to TAPE

3 Press REC to start recording.

PLAY is pressed simultaneously.

To stop recording, press STOP/EJECT.

To erase a recording, set function to TAPE and start

recording.

To turn off the unit, set function switch to TAPE.

To listen with the headphones, connect headphones with a stereo mini plug to the PHONES jack.

If an erroneous display or malfunction occurs, disconnect the AC cord and remove all the batteries

to turn off the display. Then turn the power back on.

I GENERAL

Please check the copyright laws relating to recordings from disc, radio or external

tape for the country in which the machine is being used.

Tuner section

Frequency range, FM: 88~108MHz

AM: 540~1600KHz

Deck section

Track format- 4 track, 2 channels / Frequency range-

Normal tape / Recording system ,AC bias /Erasing

system-Magnet erase / Heads- Recording / playback

head , Erasure head

CD player section

Disc- Compact Disc- CD/MP3/Scanning method

-Non-contact

optical scanner (semiconductor laser)

J SPECIFICATIONS

General

Speaker- 78 mm full-sound (2),120 mm woofer (2) /

Output-Headphones jack (stereo 3.5mm),karaoke jack

(mono 3.5mm) / Power output- 3.5W+3.5W (10%THD)/

Power requirements- DC 15 V using ten size D batteries,

DC jack in: DC 12~15V/1.5A, AC 230V, 50Hz / Weight -

5Kg (excluding batteries) /

Dimensions - 560(W)x208(H)x226(D) mm

Accessory- AC cord (1).

Specifications and external appearance are

subject to change without notice.

1 Set function to RADIO.

2 Select a band with the BAND switch.

3 Tune to a station with TUNING control.

4 Turn VOLUME and BBS to adjust the sound.

NOTE: BBS is a base boost function.

For better reception - Extend the FM antenna and adjust

it for the best reception; AM antenna is inside the unit.

Position the unit for the best reception.

FM /FM ST

Sets the FM sound to stereo or monaural.

F TUNER OPERATION

FM ST: Reception is stereo.

FM: When an FM stereo broadcast contains noise,

set to FM. Noise is reduced, although reception is

monaural.

NOTE

If the unit picks up noise from other electrical appliances

nearby, like a TV or fluorescent lights, move the unit away.

1 Microphone plug diameter is 3.5mm.

2 Connect the microphone to microphone socket for karaoke.

IMPORTANT

Make sure that f is set to TAPE before connecting

the AC cord or inserting batteries.

CAUTION

Use only the supplied AC cord. Use with other cords may

result in the risk of fire.

Using on batteries

Open the lid of the battery compartment on the rear and

unction

C POWER SUPPLY

The batteries need to be replaced when:

The tape speed slows down, volume decreases, or

sound is distorted during operation.

notes on batteries

Do not mix different types of batteries or old batteries

with new ones.

Never recharge the batteries, apply heat to them or

take them apart.

Remove dead batteries.

If liquid leaks from the batteries, wipe thoroughly to remove.

D MAINTENANCE

To clean the cabinet

Use a soft cloth lightly moistened with mild detergent

solution. Do not use strong solvents such as alcohol.

benzine or thinner.

To clean the heads and tape paths

After every 10 hours of use, clean the Recording

heads and Playback head , the pinch roller and

capstan .Use a cotton swab 5 slightly moistened with

cleaning fluid or denatured alcohol.

Cassette tapes

To prevent accidental erasure, break off the plastic tabs

on the cassette tape after recording with a screwdriver

or other pointed tool.

To record on the tape again, cover the tab openings with

adhesive tape, etc.

E CD OPERATION

insert ten (size D) batteries, not supplied, with the and

marks correctly aligned. then close the lid.

To switch from AC power supply to battery power supply,

disconnect the AC cord from the AC inlet.

CD/MP3 OPERATION

1.Set function switch to CD position.

2.Open the disc compartment and place the disc, close

the compartment and the disc will start playing

automatically.

3.Press PLAY/PAUSE to control PLAY/PAUSE mode,

, to shift between play and pause.

4. .

Press repeatedly

Turn Volume knob to adjust the sound volume

(SKIP UP) (SKIP

UP)

(SKIP DOWN)

(SKIP UP)

(SKIP DOWN)

5.Press to play next track, hold

to fast forward search the current track.

6.Press to play previous track, hold

to fast backward search the current

track.

7.Press STOP key to stop playing.

8.Press MODE to select the repeat mode when playing

a CD disc. ( REP RND NORMAL)

9.Press MODE to select the repeat mode when playing

MP3.When the player is stoped in MP3

mode, press and hold the MODE key for 3 seconds to

enable selection of folders,presss or

to select the folder, the LCD flickers.

Then press MODE.( REP ALBUM RND

NORMAL) then press PLAY.

REPEAT

Press REPEAT once- the indicator lights up and flash:

A single track is played repeatedly. Select a track

with or .

Press REPEAT twice- the indicator lights up:

All tracks are played repeatedly.

PROGRAM

In stop state, press PROGRAM and use skip/search

to select the track repeat until done then press play to

start program play. the programme memory is 99 tracks.

Batteries

Remove batteries when the appliance is not to be used for a long time. Batteries left in equipment

may cause damage through deterioration and corrosive leakage, invalidating the guarantee.

To protect the environment please use local recycling facilities for battery disposal.

Important Safety warnings

To prevent electric shock, do not remove any cover.

If anything goes wrong, don't try and fix it yourself, get a qualified service agent to look at it.

Do not expose this equipment to dripping or splashing or place any objects filled with liquids,

such as vases, on the equipment.

Never put a naked flame source on or near the equipment.

Never operate the equipment while driving a vehicle.

NOTE

Do not use irregular shape CDs(example: heart-shaped,

octagonal ones). It may result in malfunctions.

Do not place more than one disc in the disc

compartment.

Do not try to open the disc compartment during play.

Do not touch the lens. Doing so may cause malfunctions.

Press and hold the PROG button to cancel the programming.

GB-3 GB-4

Marquant MPR51 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Marquant MPR51

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info