Bedienungsanleitung Metabo ASR 35 M ACP (Seite 17 von 136) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

595131

Zoom out

Zoom in

Vorherige Seite

1/136

Nächste Seite

ENGLISH

ENG

Switch off the appliance, remove the mains plug

and open the snap locks (10). Remove the upper

part (9) from the container (11).

On the inside of

the suction

opening, push the

red rotary slide

with its "circle"

marking upwards.

(To twist the slide, push it slightly towards the

suction hose, and pull it back after twisting).

Hold the PE filter bag (6) on the flange and, with its

opening, guide it first over the latch at the bottom

part of the suction opening, then fit up to the stop

on the suction opening.8

Spread out the PE filter bag (6) evenly across the

container floor. Arrange the edges of the PE filter

bag around the container rim so that the bag is

firmly clamped on all sides by the upper part (5),

once replaced.

7.1 Switching On/Off,

Automatic

, Auto-

Clean

Select the required operating mode using the

switch (2)

Position "0":

•

Vacuum cleaner is switched off

Position "I":

•

Vacuum cleaner is switched on

•

AutoClean* is switched off

Position "IR":

•

Vacuum cleaner is switched on

•

AutoClean* is switched on

Position "AR":

•

Automatic On/Off switch: The vacuum

cleaner is switched on or off by means

of a power tool connected to the mains

socket (4). (Note: The vacuum cleaner continues to

run for approx. 10 seconds after the power tool is

switched off. This is to ensure that dust does not

remain in the hose.)

•

AutoClean* is switched on

* AutoClean

(Automatic Vibrate function): auto-

matic filter cleaning when you switch on the

appliance and when a specified vacuum value is

reached. For filters that remain clear, with no

need to interrupt work.

7.2 Power socket (4)

The power socket (4) is designed for

connection to a power tool only.

The total maximum permissible current

consumption (of vacuum cleaner and

connected unit) must not exceed the value I

max

(see table, page 2).

Caution! Ensure that the power tool is

switched off when plugging it in. Regardless

of the switch position, the plug socket is always

live when the mains plug is plugged in.

If the switch is (2) in the "0" position, you can use

the plug socket as an extension lead (e.g. for a light

fitting).

If the switch (2) is in the "AR" position, the vacuum

cleaner is switched on or off by means of a power

tool connected to the mains socket (4).

7.3 Suction control regulator

(ASR35

AutoClean only)

Using the suction power regulator (1), you can

adjust the motor speed and thus the suction power

continuously to the working conditions.

7.4 Volume flow control display

The volume flow control display lights up when the

container is full and/or if the suction hose is

blocked.

(3). In the case of ASR35M

AutoClean

an acoustic signal is also issued.

7.5 Rotary switch for setting the suction

hose diameter

(ASR35

AutoClean only)

Adjust the rotary switch (5) to the hose diameter of

the suction hose fitted.

The volume flow is being monitored if switch (2) is

at the "AR" or "IR" position.

If the volume flow falls below

set

value, the filter

cassettes (18) are automatically vibrated (without

any reduction in suction power). If the value still

remains too low, the

volume flow control display

lights up (in

switch position "AR"

an acoustic

signal is also sounded) to

indicate that the

container must be emptied, or that the paper filter

bag (8)/fleece filter bag (7) or the PE filter bag (6)

must be replaced

Ø 35 mm => 70 m³/h

Ø 27 mm => 40 m³/h

Ø 19 mm => 20 m³/h

Note:

If the suction hose diameter is 19 mm or less,

and if the flow conditions in the suction hose are

unfavourable, the

volume flow control display (3)

may occasionally light up and the acoustic signal

may sound, even though the paper filter bag/fleece

filter bag does not yet need to be emptied. In this

case, lay out the tube straight and clean it.

7 The Appliance

plastic

FFO

17027067_0711 ASR 35 L_M AutoClean ENTWURF.book Seite 17 Montag, 25. Juli 2011 4:46 16

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Metabo ASR 35 M ACP Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info