595131
18
Zoom out
Zoom in
Vorherige Seite
1/136
Nächste Seite
18
ENGLISH
ENG
Note: If you need to turn the rotary switch to a
lower value because of a machine generating dust
(e.g. small diameter of suction canal in the
machine generating dust, compared to large
suction hose diameter) (5), there is no guarantee
that dust will be conveyed adequately in the
suction hose. The suction hose must be removed
from the machine generating dust after every oper-
ating sequence, so it can be vacuumed clear.
8.1 Dry Vacuuming
Vacuum using a dry filter, dry appliance and dry
accessories only. If the cartridge is damp, dust
may stick and form a crust.
Always use filter cassettes (18) when using paper
filter bags (8), fleece filter bags (7) or PE filter bags
(6) .
8.2 Wet vacuuming
Never operate the machine without inserting
a filter cassette first (18) The machine may be
destroyed and water may also escape.
Vacuum without a paper filter (8) bag. You can use
either fleece filter bags (7) or PE filter bags (6). The
filter cartridges (18) are suitable for wet vacu-
uming.
Before carrying out any wet vacuuming, remove
the dry vacuumed material. This process will
prevent severe soiling and encrustation.
The integrated water sensor switches off the motor
when the container is full. Empty the appliance. If
the appliance is not switched off, the restart
protection device remains effective. The appliance
is not operable again until it has been switched off
and switched back on again.
After switching off, some water may run back out
of the hose.
Before emptying, first of all take the suction hose
out of the liquid.
If you are then going to dry vacuum, insert a dry
filter. If there is frequent switching between dry
and wet vacuuming, we recommend the use of a
second (replacement) filter. Allow the filter,
container and accessories to dry: otherwise dust
may adhere to damp components.
8.3 Special instructions for
ASR 35 M AutoClean:
Use as industrial vacuum cleaner (IS):
Turn switch (2) to the "IR" position.
Adjust the rotary switch (5) to a diameter of 35 mm.
If the volume flow falls below the set value
, the
volume flow control display
lights up to indicate
that the container must be emptied, or that the
paper filter bag (8) /fleece filter bag (7) or the PE
filter bag (8) must be replaced
.
Use as a dust extractor (ENT):
The dust extractor must not be connected to more
than one dust source.
Turn switch (2) to the "AR" position.
Adjust the rotary switch (5) to the hose diameter of
the suction hose fitted. For more detailed informa-
tion, see section 7.5.
Connect the power tool (deactivated) to the plug
socket (4). See section 7.2.
If the volume flow falls below
a
set
value, the filter
cassettes (18) are automatically vibrated (without
any reduction in suction power). If the value
remains too low, the
volume flow control display
lights up and an acoustic signal is also issued:
indicating
that the container must be emptied or
the paper filter bag (8)/fleece filter bag (7) or the PE
filter bag (6)
must be replaced.
8.4 Transport
In the case of the ASR 35 L AutoClean, leave the
hose on the appliance to prevent dust accidentally
escaping.
In the case of ASR 35 M AutoClean, seal the
suction opening (14) with a sealing plug (13) and
join the hose ends to prevent dust from escaping.
Wrap the suction hose about the vacuum cleaner.
Place the accessories in a suitable plastic bag and
seal the bag.
Suspend the mains connection lead on the
cable
holder
(12).
The upper part (9) must be securely sealed to the
container (11) - check that the snap locks (10) are
closed.
9.1 General Cleaning Instructions
Clean the container and accessories with water.
Wipe the upper part (9) with a damp cloth.
Caution! This appliance contains dust that is
harmful to health. Discharge and maintenance
operations (including disposal of the dust collec-
tion containers) must only be carried out by quali-
fied specialists wearing appropriate protective
clothing and equipment.
8Use
9 Cleaning
17027067_0711 ASR 35 L_M AutoClean ENTWURF.book Seite 18 Montag, 25. Juli 2011 4:46 16
18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Metabo ASR 35 M ACP wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info