Bedienungsanleitung Metabo TS 254 (Seite 26 von 188) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

633940

Zoom out

Zoom in

Vorherige Seite

1/188

Nächste Seite

ENGLISH

Every time the machine is switched

off

Check whether the saw blade overrun

exceeds 10 seconds; if the overrun is

longer than this, have the motor re-

placed by a qualified electrician.

Monthly (if used daily)

Remove saw dust and chips with vacu-

um or brush; apply light coat of oil to

guide elements:

– threaded rod and guide rods of

blade rise and fall mechanism:

–swivel segments.

Every 150 hours of operation

Check all screwed joints, retighten if

necessary.

If necessary:

Set table leg guide bushings.

 Turn Allen screws (73a) clockwise =

guide sluggish.

 Turn Allen screws (73a) counter-

clockwise = guide moves easily.

 Further fine adjustment by means of

a setscrew (73b).

Setting guide bushings on front leg

mount:

 Turn Allen screws (74) clockwise =

guide sluggish.

 Turn Allen screws (74) counter-

clockwise = guide moves easily.

Setting guide bushings on rear leg

mount:

 Turn Allen screws (75) clockwise =

guide sluggish.

 Turn Allen screws (75) counter-

clockwise = guide moves easily.

Tighten all Allen screws diagonally

and evenly.

 Before cutting a workpiece to size

make trial cuts on pieces of scrap.

 Always place a workpiece on the saw

table in such way that it cannot tilt or

rock (e.g. always place a curved

board on the table with the convex

side up).

 To simplify repetitive cut-off work

use a stock stop.

 Keep surface of table clean.

Use only genuine Metabo accessories.

Use only accessories that fulfil the re-

quirements and specifications listed in

these operating instructions.

For a complete range of accessories,

see www.metabo.com or the catalogue.

Danger!

For safety reasons, repairs to power

tools must be carried out by quali-

fied electricians only using original

spare parts!

If you have Metabo electrical tools that

require repairs, please contact your Me-

tabo service centre.

For addresses see www.metabo.com.

You can download spare parts lists from

www.metabo.com.

Power tools do not belong in

the household rubbish.

According to European Di-

rective 2002/96/EC on waste

electrical and electronic

equipment, used electrical devices must

be collected separately and taken to an

environmentally friendly recycling ?facil-

ity.

Contact your local council for informa-

tion on disposal of the used tool.

All packaging materials are recyclable.

Danger!

Before carrying out any fault service

or maintenance work, always:

1. switch machine off.

2. unplug mains cable.

3. wait for saw blade to come to

standstill.

Check that all safety devices are op-

erational again after each fault ser-

vice.

Motor does not run

The restart protection is active. If the

mains plug is inserted with the machine

switched on, or if the current supply is

restored following an interruption, the

machine does not start up:

 Switch the machine off and on

again.

No mains voltage

 Check cables, plug, outlet and

mains fuse.

Motor overheated, e.g. by a blunt saw

blade or chip build-up in the chip case:

 Remove cause for overheating, let

cool off for a few minutes. Then re-

start machine.

Speed is not reached

Overload protection: There is a MAJOR

reduction in load speed.

 The motor temperature is too high!

Allow the machine to run at idle

speed until it has cooled down.

Overload protection: There is a SLIGHT

reduction in load speed.

73a

73b

9. Tips and Tricks

10. Available Accessories

11. Repairs

12. Disposal

13. Troubleshooting

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Metabo TS 254 Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info