R331 Rechargeable Remote Control
11. Channel Control Setup Options
The channel controls (Channel Up/Down, 0-9 and LAST) will always work your Set-top. If you'd
like the channel commands to be sent to different devices depending which mode you are in.
A. Channel Control Depends on Device Selected
1. Press and hold the TV key and while holding it pressed, press the OK key for one
second.
2. Release both keys, all of the mode keys flash followed by the TV mode key light
remaining on.
3. Press and hold the LAST key for 3 seconds until the TV mode key light briefly turns off
then stays on, then release the LAST key.
4. Press and release the LAST key to save the setting. The TV mode key light turns off
indicating successful setup. The channel commands will now work for different devices.
B. Channel Always Controls your Set-top (Factory Default)
1. Press and hold the TV key and while holding it pressed, press the OK key for 1 second.
2. Release both keys, all of the mode keys will flash followed by the TV mode key light
remaining on.
3. Press and hold the LAST key for 3 seconds until the TV mode key light briefly turns off
then remains on.
4. Press and release the STB mode key. The selected mode key light remains on.
5. Press and release the LAST key to save the setting. The STB mode key light will turn
off indicating a successful initial setup. The channel commands will be setup for your Set-
top regardless of what mode is selected. If the selected mode key light flashes for 3
seconds and turns off, then you will need to start over from step 1.
12. Mode Deactivation
If you'd like to deactivate a device mode, then follow the instructions below:
1. Press and hold the mode key to be deactivated (TV, DVD, or AUX) and while holding it
pressed, press the OK key for one second.
2. Release both keys, all of the mode keys will flash and then the selected mode key light
will remain on.
3. Enter the 4-digit code 1754 by pressing the numerical keys (0-9). The selected mode
key light will blink for each digit entry and will remain off after the entry of the fourth digit -
indicating the mode is deactivated.
Note the STB mode cannot be deactivated.
