Bedienungsanleitung Mountfield EL 420 Li 48L (Seite 29 von 42) (Englisch, Italienisch)

765495

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

EN - 2

2.2 PRELIMINARY PROCEDURES

• Always wear suitable work attire, hard-wearing safety

footwear with non-slip soles and long trousers. Do

not operate the machine when barefoot or wearing

open sandals. Wear hearing protection devices.

• Never wear scarves, shirts, necklaces, bracelets,







• Tie your hair back if it is long.

• Wear protective gloves whenever your hands are at risk.

• Thoroughly inspect the entire work area and

remove anything that could be thrown by the

machine or damage the blade/rotating units

(stones, branches, iron wire, bones, etc.)

2.3 DURING OPERATION

• Do not use the machine in environments at risk



liquids, gas or powder. Power tools create

sparks which may ignite the dust or fumes.

• Do not expose the machine to rain or wet

environments. Water entering a power tool

will increase the risk of electric shock.

• 

light in good visibility conditions.

• Avoid working with wet grass, in the rain and when

there is a risk of a thunderstorm, especially lightening.

• Pay careful attention to uneven ground

(hills, dips), slopes, hidden hazards and

obstacles that could limit visibility.

• Be very careful near ravines, ditches or embankments.

The machine could overturn if a wheel slides

over the edge or if the earth gives way.

• Always mow across a slope and never up and

down. Being very careful when changing direction,



wheels do not hit any obstacles (such as stones,

branches, roots, etc.) that may cause the machine

to slide sideways or make you lose control of it.

• The machine must not be used on slopes over

20°, regardless of the mowing direction.

• Do not incline the lawnmower during



without obstacles or high grass.

• Exercise caution when pulling the lawnmower

towards you or moving backwards. Look behind

you to make sure there are no obstacles.

• Never run, always walk.

• Do not allow the lawnmower to pull you along.

• Always keep hands and feet away from the blade,

when starting and when using the machine.

• Keep away from the discharge opening.

• Never operate the machine with damaged, missing

or incorrectly assembled guards (grass catcher,

side discharge guards, rear discharge guards).

• Never disengage, deactivate, remove or tamper

with the safety systems/micro switches installed.

If something breaks or an accident occurs during

mowing, turn o the motor immediately and move the

machine away to prevent further damage; if an

accident occurs with injuries or third parties are

injured, carry out the rst aid measures most suitable

for the situation immediately and contact the medical

authorities for any necessary health care. Carefully

remove any debris which could cause damage or injury

to persons or animals if ignored.

2.4 MAINTENANCE, STORAGE

Ensure regular maintenance and correct storage to

maintain machine safety and high performance levels.

• 

or damaged components. If necessary, replace the

damaged components and tighten any screws and

loose bolts or contact the authorised service centre.

• Never use the machine with worn or damaged parts.

Faulty or worn-out parts must always be replaced and

never repaired. Use original replacement parts only.

• 





• 

with debris inside a room.

• Store the machine:

– Covered with a sheet where possible.

– In a place where children cannot get to it.

– Making sure that keys or tools used

for maintenance are removed.

• Make sure that machine movements do



The noise and vibration levels shown in these

instructions are the maximum levels for use of the

machine. The use of an unbalanced cutting element,

the excessive speed of movement, or the absence of

maintenance have a signicant inuence on noise

emissions and vibrations. Consequently, it is necessary

to take preventive steps to eliminate possible damage

due to high levels of noise and stress from vibration.

Maintain the machine well, wear ear protection devices,

and take breaks while working.

2.5 BATTERY / BATTERY CHARGER

IMPORTANT The following safety instructions

are in addition to the safety requirements

provided in the specic battery and battery

charger manual delivered with this machine.

• Only use battery chargers recommended by the

manufacturer to recharge batteries. An inadequate

battery charger may cause electric shock, overheating

or corrosive liquid to leak from the battery.

• 

your power tool. The use of other batteries



• 

inserting the battery. Inserting a battery in a



• Keep all unused batteries at a distance from

paper clips, coins, keys, nails, screws or other



can cause short circuits. Short circuits between



• Never use the battery charger in environments in





paper, fabric, etc. The battery charger heats



Mountfield EL 420 Li 48L Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info