Bedienungsanleitung MTD CubCadet serie 6000 (Seite 22 von 25) (Englisch)

507839

Zoom out

Zoom in

Vorherige Seite

1/25

Nächste Seite

User manual English

 Turn the draining tap (a) anti-

clockwise. Allow the water on the

base of the filter to drain until pure

diesel runs from the tap.

 Turn the draining tap (a)

clockwise.

 Slowly, turn the ventilation knob

(b) anti-clockwise until fuel starts

to run from it. Close the ventilation

tap (a) clockwise.

Cleaning the cooler and cooler

grille

 To remove the cooler grille, open

the bonnet and carefully take out

in the middle where the tounges

are. In order to clean its surface,

rinse the grille with water.

 Check the engine and

transmission oil cooler ribs for

accumilation of dirt between the

ribs. Blow out dirt from the cooler

with compressed air from the

engine ventilator side.

 Reinsert the grille, however at the

same time make sure that it is

inserted into the slots of the

cooler frame.

Checking the coolant

=t~êåáåÖ

Ó ^=ä~Åâ=çÑ=Åççä~åí=äÉ~Çë=íç=ëÉêáçìë=

ÉåÖáåÉ=Ç~ã~ÖÉ=

Ó `~êêó=çìí=~=ÅÜÉÅâ=ÄÉÑçêÉ=ëí~êíáåÖ=

íÜÉ=ÉåÖáåÉ=EÑçê ÅçäÇ=ÉåÖáåÉëFK

To top up, use a mixture of water

and anti-freeze agent with a 1:1

ratio.

Note

If the local water supply is hard or is

polluted in some other way, use

distilled water for the mixture.

Observe the notes provided by the

anti-freeze agent manufacturer and

those in the engine manual.

Fig. 16

 Open the engine bonnet.

 Check the coolant level on the

adjustment container.

 If the coolant level is below the

MIN-mark, open the container

and fill it with the coolant mixture

up until the MAX-mark.

 Close the engine bonnet.

Check that it is fully engaged.

Inspect/exchange the air filter

insert

Inspect the air filter daily or before

starting the engine. Inspect for loose

or damaged components and check

the condition of the filter element.

Remove accumulations of dirt in the

air filter housing.

Exchange the paper filter element

after 300 hours of operation. Do this

more often is the the tractor is used

in very dusty conditions.

Inspect and/or exchange the air filter

as follows:

 Open the clips (1) in order to take

the housing lid off (2).

 Remove the filter element (3) from

the housing (4).

 Carefully blow away loose dirt

from the filter element. Clean the

housing.

 Inspect the paper fins of the filter

for damages and dirt. Inspect the

sealing surface at the inner end of

the filter element for wear and tear

or damages. Exchange damaged

or soiled filter element.

 Press the new air filter completely

into the housing.

 Preplace the lid. Attach the two

clips to the edge of the housing

and engage.

Note

A clean and correctly fitted air filter

significantly contributes to the

longevity of the engine

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

MTD CubCadet serie 6000 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von MTD CubCadet serie 6000

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info