Bedienungsanleitung NAD T 567 (Seite 16 von 30) (Englisch)

493500

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

2 A menu prompts you to select “Yes” to reset any existing connection

or “No” to retain current connection. Select “Yes”. Use [A/S/D/F] to

congure your connection with below OSD.

Static: Select to set manually the IP address, Subnet Mask, Gateway and

consequently the DNS Server settings.

Dynamic: Select to automatically allocate an IP address.

3 After selecting either “Static” or “Dynamic”, click “OK” to complete the

network connection.

4 After setting up the connection, a menu will prompt you test your

network connection. Click “OK” to complete the network connection

and exit the “Connection Setting” menu.

5 If “Test” is selected, the network connection status is displayed as in below

WIRELESS NETWORK

Another connection option is to use an Access Point or a wireless router.

The network conguration and connection method may vary depending

upon the equipment used and the network environment.

The T 567 is equipped with an IEEE 802.11n wireless module, which also

supports the 802.11a/b/g standard. For the best wireless performance, it is

recommended that an IEEE 802.11n certied Wi-Fi network (access point or

wireless router) is used. For detailed connection steps and network settings,

refer to the setup instructions supplied with your access point or wireless router.

1 Select “Wireless” from the “Connection Setting” menu.

2 A menu prompts you to select “Yes” to reset any existing connection

or “No” to retain current connection. Select “Yes”. Use [A/S/D/F] to

congure your connection with below OSD.

Manual: The AP name (SSID) of your access point may not be

broadcasting. Check your router settings through your computer and

either set your router to broadcast SSID, or manually enter the AP name

(SSID). Follow the consequent OSD prompt sequence and enter the

necessary information or congurations.

Push Button: Select if your access point or wireless router supports

Push Button Conguration method. Within 2 minutes upon selecting

“Push Button”, press the Push Button on your access point or wireless

router. You do not need to know the AP name (SSID) and security code

of your access point or wireless router.

3 Follow the same steps 2-5 of the above WIRED NETWORK procedure to

complete your wireless network connection settings.

IMPORTANT NOTICE

You can also directly select an Access point name or SSID from the list that is

shown after Step 2 above. For example, use [D/F] to select “NADLAB”. Press

[ENTER]. After selecting, you will be redirected to another window where you

are to type a password or access point name.

OPERATION

USING THE T 567

ENGLISH PORTUGUÊSFRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

NAD T 567 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von NAD T 567

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info