Bedienungsanleitung NAD T 775 (Seite 31 von 46) (Englisch)

602917

Zoom out

Zoom in

Vorherige Seite

1/46

Nächste Seite

CHOOSING THE TUNER MODE

The front-panel ‘TUNER MODE’ key is a dual-purpose control. In the normal

position, FM Mute FM Stereo icons on the VFD are illuminated, only the

stations with a strong signal can be listened to, and the noise between

stations is muted.

Pressing the ‘TUNER MODE’ button again (FM Mute FM Stereo icons on the

VFD are extinguished) allows distant and potentially noisy stations to be

received. Noise is reduced if the FM station signal level is less than the FM

Stereo threshold (since mono FM is inherently less noise-prone) though at

the sacrice of the stereo eect.

NOTE

 Onecanstorethesamechannelintwopresetlocations-onewith

TUNERMODEOnandanotherwithTUNERMODEO.

ABOUT USER NAMES

You can assign an eight character “User Name” to each radio preset, which

will show in the front-panel readout whenever that preset is recalled.

ENTERING USER NAMES

To name a radio preset “NEWS,” follow the procedure as below (The buttons

mentioned apply to the front panel’s buttons. The applicable HTR 3 keys

also execute the same functions as described).

1 Recall the desired radio preset.

2 Then, press the ‘MEMORY’ button once and then within ve (5) seconds,

press the ‘INFO’ button - the readout shows a blinking box.

3 Use the ‘PRESET / ‘ buttons to select the rst character of the

name (“N” from the alphabetical list).

4 Press ‘TUNE ’ button to select the character and correspondingly

move forward to the next position. (Press TUNE to go back to the

previous character). Repeat this process for each character in sequence.

5 Press the MEMORY key again to store the User Name and exit the text-

entry mode.

ABOUT RDS

The Radio Data System (RDS) permits compatible FM A/V Receivers to

display text determined by the broadcaster. The T 775 supports two RDS

modes, station-name (PS mode) and radio-text (RT mode). However, not

every FM station incorporates RDS in its broadcast signal. In most areas you

will nd from one to several RDS-enabled stations, but it is by no means

impossible that your favorite stations will not be broadcasting RDS data.

VIEW RDS TEXT

When an RDS-enabled FM broadcast is tuned, after a brief delay the “RDS”

symbol will illuminate in the T 775’s front-panel readout and the readout’s

character section will show its station-name (PS) text: “ROCK101,”for

example.

Press the front-panel INFO key to toggle the readout between this and the

station’s radio-text (RT) readout, if any, which might scroll song- or artist-

name, or any other text of the station’s choosing.

LISTENING TO XM RADIO

The T 775 is “XM Ready” which means that with the addition of separately

sold XM Mini-Tuner CPC-9000 and XM Mini-Tuner Home Dock, it has

everything you need to listen to live XM. Everything else is built right in.

Just subscribe to the XM service and your T 775 will be ready to receive XM

content.

NOTES

• WhenusingtheHTR3tocarryoutXMcommands,ensurethatthe

DEVICESELECTORissetto“TUNER”.

• InXMmodeandwithDEVICESELECTORsetto“TUNER”,HTR3’s[FM

MUTE]buttonhasthesamefunctionasthatofthefrontpanel’s[TUNER

MODE]button.

• CheckwithyourNADaudiospecialistforotherversionsofXMMini-

TunercompatiblewithT775.

IMPORTANT NOTICE

 Unlessotherwisespecicallystated,navigatingoraccessingXMfunctions

canbeundertakenbyusingeithertheHTR3remotecontrolorthefront

panelbuttons.Ifthecontrolbuttonoriconbuttonbeingreferredtois

availableontheHTR3remotecontrolandfrontpanel,thenthereferenceto

saidbuttonisapplicabletoboththeHTR3remotecontrolandfrontpanel.

Thesameconditionappliestotheirequivalentbuttons.

CONNECTING THE XM ANTENNA

1. Plug the end of the XM antenna into the corresponding XM antenna port

on the rear panel of the T 775.

2. Press and hold “TUNER MODE” button on the front panel to check the

current XM channel’s signal strength as shown in the VFD and OSD.

Press “TUNER MODE” again to exit signal strength check.

Refer also to your XM radio’s guide on how to install the XM antenna for

optimum signal reception.

TUNING STATIONS

There are three ways to tune to the XM channel you wish to listen. Make

sure to set your HTR 3’s Device Selector to “TUNER” prior to undertaking the

following tuning options. The buttons refer to the corresponding

keys on the HTR 3. The same keys correspond to the front panel navigation

buttons “PRESET / PRESET / TUNE / TUNE .”

1 Manual Tuning : Toggle the buttons to step up or down each

available XM channel. Press and hold for faster scanning of XM

channels. The HTR 3 keys “TUNE / TUNE ” will likewise execute

these same functions.

2 Direct Channel Call : Using the numeric keypads of the HTR 3,

key-in directly the desired available channel number and it will be

automatically tuned.

3 Category : Toggle “TUNER MODE” until “CAT

” and a corresponding

category is displayed on the VFD. “CAT

” stands for the categories

channels are grouped into – i.e., Country, Rock, Jazz & Blues, etc. Toggle

buttons to step up or down the available categories.

After selecting the desired category, use the same steps as that of

XM Manual Tuning. Tuning will only be limited to within the selected

category. Toggle the buttons to choose another category and

then tune again.

OPERATION

USING THE T 775  AM/FM/DB/iPod

ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ

NAD T 775 Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von NAD T 775

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info