Bedienungsanleitung Naim HDX (Seite 6 von 30) (Englisch)

707495

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

Installation - Getting Started

2 Getting Started

The HDX-SSD is a CD-ripping hard disk player and server. It incorporates no built-in

storage but requires an external network attached storage disk drive (a NAS drive) to be

connected and configured before it can be used. Configuring a NAS drive is described in

Section 7 of this manual.

HDX-SSD must be connected to a network to stream music around the home, or to take

advantage of many of its user interfaces. It must also be connected to the internet to

retrieve album data and artwork from the internet, It is important that the network is

working when HDX-SSD is connected and switched on.

HDX-SSD should be installed horizontally on a dedicated equipment stand intended for

the purpose. Do not stand HDX-SSD directly on top of another item of equipment. HDX-SSD

should be installed in its final location before connecting cables or switching on.

Locally connected audio amplifiers should not be switched on before HDX-SSD is switched

on. The HDX-SSD power switch is located on the rear panel.

To begin installation first identify the rear panel network, audio output and power input

sockets, and connect the appropriate cables.

2.1 Internet/Network Connections

Unitiserve-SSD requires a connection to network attached

storage in order to operate, and an “always on” internet

connection if its full capabilities are to be realised. It should

be connected to the internet via an ethernet router/

modem with a built-in firewall

The network connection also enables HDX-SSD to

communicate with other network devices, to be used in a

NaimNet/StreamNet network audio system, and provides

access to its alternative user interfaces.

The HDX-SSD is set up when originally shipped not to

require any further network configuration but to connect

to a network automatically (it uses DHCP by default).

However, if your HDX-SSD has been previously used, its

network configuration may have been altered leaving it

unable to connect automatically. Contact your retailer,

installer or Naim Audio directly if this appears to be the

case.

2.1.1 Network Hardware

Wired network connection is strongly recommended for

the most consistent and secure HDX-SSD operation.

Ethernet-over-mains hardware may be used and provides

a simple and convenient method of home network

connection. However, depending on mains wiring factors

specific to each home environment, the presence of

network data on the mains supply may compromise

overall system sound quality. If any sound quality

compromise is found to be unacceptable, dedicated

network cabling should be installed.

2.2 Power Supply Upgrade

The HDX-SSD can be upgraded through the use of an

external Naim XPS or CD555PS external power supply to

power its analogue circuits.

If an external power supply is to be used, the link plug in

the rear panel of the HDX-SSD should be removed and the

power supply connected in its place using an SXPS Burndy

cable. See Diagram 3.3.

THE SXPS BURNDY CABLE ONLY MUST BE USED TO CONNECT

THE XPS OR 555PS POWER SUPPLIES.

Both the HDX-SSD and the external power supply must be

switched off when the link plug is removed and the Burndy

connections are made. Switch on the external power

supply first followed by the HDX-SSD.

2.3 Audio Connections

Connect one or all of the analogue DIN (output 1) or Phono

(output 2) output sockets, or the Digital output socket, to an

appropriate audio system input. If using the analogue outputs

use a Naim Hi-Line interconnect cable for best results.

Note: The output selector on the rear panel should be

switched to reflect the analogue output connections used.

2.3.1 Signal Ground

Switch the HDX-SSD’s rear panel Signal Ground switch (see

paragraph 3.2.14) to the Chassis position unless the HDX-

SSD is connected in a hi-fi system incorporating another

earthed source component, or mains “hum” is audible

through the loudspeakers. Contact your retailer, distributor

or Naim for advice if necessary.

Note: All Naim CD players are earthed so the Signal

ground switch should be set to floating if one is connected

in the system.

Note: “Connected” in this context means an analogue

audio signal cable that includes an earth connection.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Naim HDX Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Naim HDX

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info