Bedienungsanleitung Naim HDX (Seite 7 von 30) (Englisch)

707495

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

Installation - Getting Started

2.4 Switch On

If the HDX-SSD’s network facilities are to be used ensure

that it is connected to a working internet connection

before switching it on and that all the necessary peripheral

equipment is appropriately connected and configured.

Switch on the HDX-SSD using the rear panel power switch.

Note: If the HDX-SSD is to be switched on from shutdown

mode, the power switch must be switched off and on again.

See Section 2.8 for more on shutdown mode.

After approximately one minute’s delay, the user interface

Home menu will appear on the front panel touch screen

(and any connected display). Navigate around the

interface and select options by touching the screen or

using the remote handset navigation (3456), ok, home

and back keys.

Note: It is occasionally possible for the default remote

handset command set to conflict with other remote

controlled equipment in the home. A conflict will be

apparent if the handset appears to control an unintended

device or if another handset appears to control the HDX-

SSD. If a conflict occurs the HDX-SSD handset command set

can be changed. While pointing the handset towards the

HDX-SSD, press and hold both the page down and input

keys while simultaneously pressing the 2 or 3 key to change

the command set. Press the 1 key to return to the default

command set.

2.5 External Screen Setup

If an external display is used, the HDX-SSD external display

setup may need to be modified. Navigate, via the System

menu, to the System Setup menu. Select and save the

desired External Display Theme, External Display Aspect

Ratio, External Display Mode and TVSystem. Initially disable

the Screen Saver (found on System Setup page 1).

Note: The External Display Mode setting configures the

external display for use with either an external touch

screen or a remote handset. In touch screen mode, four

shortcut buttons are displayed on the right of the screen

that correspond to the home, browse, find and back keys

on the remote handset. The on screen shortcut buttons

can only be accessed from the touch screen so are not

shown in remote control mode.

Note: Once you have become used to the interface and

are familiar with its functions the screen saver can be

re-enabled.

2.6 First Use

Before attempting to rip a CD you must ensure that the

necessary Network Attached Storage (NAS) disk drive is

appropriately configured, connected to the network, and

switched on. Section 7 of this manual describes the use

and configuration of external storage.

To rip a CD, insert the CD into the transport slot. The ripping

process will begin automatically. When CD ripping is

complete HDX-SSD will eject the CD automatically. See

Section 6 for further information on ripping CDs.

Only CDs owned personally should be ripped. Ripping a

borrowed CD may violate copyright law.

Note: Although the HDX-SSD contains a small internal music

database, to be able to identify a CD and download its

associated data during the ripping process, it must be

connected to a working internet connection.

2.7 Software Upgrade

Software upgrade CDs will occasionally be released for the

HDX-SSD. New software is installed simply by inserting the

upgrade CD in the drawer. The software upgrade process

will commence automatically. As part of the upgrade

process the HDX-SSD will eject the CD and re-boot. The

front panel display may also go blank temporarily. The

upgrade process is complete once the display returns to

the Home Menu.

Note: Any specific instructions included with the upgrade

CD should be followed carefully.

Never switch off the HDX-SSD from the rear panel power

switch or unplug it from the mains supply while a software

upgrade process is underway.

2.8 Switching Off

Switching off the HDX-SSD from its rear panel power switch

is not normally necessary unless it is to be un-installed. It

can be put into shutdown mode by pressing the handset

shutdown key or pressing and holding the front panel

shutdown button for one second. The HDX-SSD may take

up to one minute to enter shutdown mode during which

time the shutdown button will flash. The shutdown button

will remain lit when the HDX-SSD is in shutdown mode. Wait

until the shutdown button stops flashing and remains lit

before switching off the HDX-SSD from the rear panel mains

switch.

Never switch off the HDX-SSD from the rear panel mains

switch or unplug it from the mains supply unless it is in

shutdown mode.

To switch the HDX-SSD back on from shutdown mode, the

power switch must be switched off and on again.

2.9 Data Backup

HDX-SSD does not incorporate an integral backup disk

drive and we strongly advise that you protect your stored

music by implementing a regular backup to a Network

Attached Storage (NAS) hard disk drive.

Implementing regular backups to a network share can be

set up via the HDX-SSD System menu. This is described in

Section 4.8.4.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Naim HDX Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Naim HDX

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info