707119
120
Zoom out
Zoom in
Vorherige Seite
1/133
Nächste Seite
(10) Release (R): Defines the amount of time it will take for the envelope to fall from the set Sus-
tain level and fade to zero.
(11) Env Level: Defines the overall level of the envelope.
(12) Velocity: Controls the influence of the incoming MIDI note’s velocity on the overall amplitude
of the envelope. When turned fully left, the envelope amplitude is not influenced by the incoming
note’s velocity. When the fader is turned fully right, the overall envelope amplitude is directly pro-
portional to the incoming note’s velocity. The Velocity button changes the slope of the Velocity
control from linear to logarithmic, when activated.
(13) Trigger: Selects one of four settings (Gate, OneShot, LoopGate, Loop), that determine the
envelope's response to incoming MIDI notes.
When Gate is selected, the envelope starts and is read out until its end. If the key is released
before the Sustain stage of the envelope, it will immediately jump to the Release stage.
With OneShot selected, the envelope is read to end, even if the key is released before the
Sustain stage.
LoopGate creates a loop between the Attack and Decay stages.
Loop creates a loop from the entirety of the envelope, including the Release stage.
(14) Reset: When active, the envelope will restart each time a note is triggered.
(15) Note Off: When active, the envelope is triggered with the note-off stage, for example when a
key is released.
(16) Mono: When activated, all incoming notes receive the same envelope shape, regardless of
pitch.
(17) Display: Provides a visual representation of the envelope shape, based on how the knobs
and menus are set. Move the controls described above to see how each parameter influences the
shape of the envelope.
19.4. Exciter Envelope
The Exciter envelope is particularly fast envelope that has been specifically designed to trigger the
Comb filter, producing a resonator in physical modelling. It also effective for creating percussive
sounds, with its quick attack and short release times.
The Exciter is unlike a standard ADSR based, multi-stage envelope generator. It is an Attack-Re-
lease envelope with short times, functioning in a single cycle, with a defined centre point and Hold
stage that maintains the peak level from Attack to Release stages.
To use this envelope as an exciter for the Comb filter, it must be assigned to one of the Modulation
Sources via the Routing page, routed to the Comb filter and then the filter routed to the output.
This enables you to set the Comb filter into oscillation and create tones from the Feedback. A low
Ratio setting produces the short envelope burst needed to create sound from the filter. For more
information, see Comb.
Modulators
116 Manual
120

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Native Massive X wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info