Bedienungsanleitung Neff C44R20N3 (Seite 16 von 24) (Englisch)

495367

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Changing the door seal

If the seal around the outside of the cooking compartment is

faulty, it must be replaced. Replacement seals for your

appliance can be obtained from the after-sales service. Please

specify the E number and FD number of your appliance.

1.Open the appliance door.

2.Pull off the old seal.

3.Push in the new door seal at one point and pull it in all the

way round. The joint must be at the side.

4.Check again that the seal is correctly fitted in the corners.

Replacing the cooking compartment bulb

The cooking compartment light in your appliance is a durable

LED light. If a fault does occur in the LED light, contact the after-

sales service. The glass light cover must not be removed

Extremely loud pumping sound during

cooking

Water tank is empty, but water is still evap-

orating in the evaporator dish

Filling the water tank

The water tank has not been inserted

properly

Slide in the water tank until it engages

Pumping sound during cooking This is normal

There is a "pop" noise during cooking Cold/warm effect with frozen food, caused

by the steam.

This is normal

When you cook with steam, a lot of steam

is created

The appliance is being automatically cali-

brated

This is normal (see section: Automatic cal-

ibration)

When cooking with steam, a lot of steam is

created again

The appliance is unable to calibrate itself

automatically if cooking times are too

short

Restore the appliance to factory settings

(see section: Basic settings) and recali-

brate the appliance (see section: Before

first use)

Steam escapes from the ventilation slots

during cooking

This is normal

The appliance is not producing steam

properly

Limescale has formed in the appliance Start the descaling programme.

Hose for the water inlet in the cooking

compartment was pushed to the side or

has hooked itself to the side of the cook-

ing compartment wall.

Strong pressure on the hose or hooking of

objects when cleaning

Call after-sales service and do not use the

appliance.

Cooking compartment light has failed The LED lamp is defective Contact the after-sales service. The glass

light cover cannot be removed

“... error message appears in the dis-

play

Technical fault.

Press the KJ clock function button to

delete the error message, and reset the

clock if necessary.

If the error message appears again, call

the after-sales service

The error message

“‹‚‚ appears in the

display

A button was pressed for too long or is

jammed

Press the

KJ clock function button to

delete the error message

Press all of the buttons individually and

check if they are clean

The appliance is not heating. The colon

flashes in the display

A button combination was activated

Press and hold the

o button for

4 seconds, then press the

Í button

Problem Possible cause Notes/remedy

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Neff C44R20N3 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Neff C44R20N3

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info