Bedienungsanleitung Nuk Eco Control Video Display 550VD - 10749102 (Seite 16 von 36) (Englisch)

803238

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

5.3 Setting the volume

We recommend switching the lullabies on

(see "5.4 Playing the lullabies" on page 54)

for setting the volume on the baby unit, as

playing them can help you decide which of

the five possible volume settings is best

suited to your purpose.

1. To activate the lullabies on the baby unit

1, press the button Lullabies on/off 12.

Note: The lullabies can also be activated

from the parent unit 17 (see

"6.11 Lullabies" on page 67).

2. Use the VOL +/- buttons 11 to set the

volume at which baby will hear the

lullabies or your voice.

5.4 Playing the lullabies

This NUK babyphone has four especially

composed lullabies and soothing natural

sounds to help you soothe your baby and

lull it to sleep.

1. To activate the lullabies on the baby unit 1,

press the Lullabies on/off button 12.

Note: The lullabies can also be activated

from the parent unit 17 (see

"6.11 Lullabies" on page 67).

2. You can change the current song by

holding down the Lullabies on/off

button 12. This automatically goes on to

the next song.

Note: If the timer function has been

activated on the parent unit (see "Activating

the timer“ on page69), and you change

from one lullaby to the next directly on the

baby unit, the timer will be restarted. If the

timer function has not been activated, the

lullaby will continue to be played repeatedly

until switched off by you on the parent unit

or the baby unit (see “Switching the lullabies

off“ on page68).

5.5 Nightlight

The baby unit’s soft nightlight can help your

baby to get its bearings in the dark room,

which it may find soothing. The nightlight

remains on until it is switched off by you or

the timer function (see "6.5 Switching the

nightlight on and off" on page 57).

1. You can switch the nightlight on or off on

the baby unit by briefly pressing the

button Nightlight on/off 13.

2. You can switch the nightlight on and off on

the parent unit (see "6.5 Switching the

nightlight on and off" on page 57).

5.6 Registering remote units

on the parent unit

The parent unit and the baby unit included

in the same delivery package will normally

connect automatically once they are

switched on.

However, you can operate up to 4 baby

units (cameras) connected to the same

parent unit. Additional baby units can be

obtained from www.nuk.de, for example.

To add one or more cameras/baby units,

follow the instructions in section

"6.7Adding and selecting a camera, and

activating patrol mode" on page 58.

5.7 Measuring the room

temperature

The baby unit has an integrated temperature

sensor which is not visible from the outside.

This sensor measures the temperature in

around the baby unit, which is displayed

and continually updated on the parent

monitor.

Notes: To avoid affecting the temperature

measurement:

– do not cover the baby unit

– do not place the baby unit near a

heater or cold surfaces

– do not place the baby unit in direct

sunlight.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nuk Eco Control Video Display 550VD - 10749102 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info