Bedienungsanleitung Nuk Eco Control Video Display 550VD - 10749102 (Seite 14 von 36) (Englisch)

803238

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Indicators

The following information is shown in the

status bar of the parent unit:

Notes:

– Charging the battery for the very first

time takes about 10 hours.

– Subsequently recharging the depleted

battery takes about 6 hours.

– With a fully charged battery, you can

operate the parent unit for up to 8

hours.

The time needed to recharge the battery and

the operating time both depend on how

heavily the parent unit is used:

– The battery can normally be recharged

in about 6 hours, but it will take longer

if the device is switched on at the same

time.

– Similarly, the operating time of up to 8

hours will be reduced if you use the

talk-back function or choose a high

volume setting.

– The operating time can be increased, for

example, if audio monitoring is activated

(see "6.9 Switching between audio and

video monitoring" on page 63), if your

baby has a particularly restful sleep, or if

the "LCD Auto Off" option for the screen

is switched on (see "Switching between

audio and video monitoring“ on

page63).

4.5 Eco-Mode and 

Full-Eco-Control

This baby monitor has an Eco-Mode

function that not only saves power but also

minimises the high-frequency radio waves in

the nursery.

In this mode, there is only limited

transmission between the baby unit and the

parent unit, although the Full-Eco-Control

function ensures that both units remain

connected the whole time. If the connection

is interrupted in Eco-Mode, this is

immediately indicated on the parent unit.

The device automatically deactivates Eco-

Mode and transmits sound and video again

as soon as your baby makes a sound that

exceeds your set sound limit (VOX levels 1 -

4).

Activating Eco-Mode

Eco-Mode can only be activated at VOX

levels 1, 2, 3, and 4 (see "6.8 Setting the

VOX sensitivity level" on page 62). Eco-

Mode is activated automatically as soon as

Battery power

Battery is full and LED 21 is lit

up green.

Battery is half-full and LED 21

is lit up green.

Battery is almost empty.

Depending on how it is being

used, the device will automati-

cally switch off within the next

15-20 minutes. We therefore

recommend that you connect

the device to mains power in

order to recharge the battery.

LED 21 is lit up green.

Battery symbol flashes red.

This means that the battery is

empty and the device will

switch off within a very short

time. LED 21 flashes and

device emits a warning beep

every 60 seconds. In addition, a

warning appears in the middle

of the screen.

Bars run across the display

LED 21 flashes green:

The device is connected to mains power

and the battery is being recharged.

The animation stops as soon as the battery

is fully charged and LED 21 no longer

flashes.

Parent unit is connected to

mains power, but no battery is

inserted. LED 21 is lit up green.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nuk Eco Control Video Display 550VD - 10749102 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info