Bedienungsanleitung Onkyo TX-DS494 (Seite 21 von 36) (Englisch)

553751

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Speaker Setup

You need to set up the speaker configuration for the speaker

system connected to the SPEAKERS A terminals (see page 17).

Notes:

•

The speakers cannot be set up for optimum audio reproduction if;

– Headphones are connected (see page 8), or

– The SPEAKERS B system is On (see page 7).

• It is not necessary to set up again once you have completed the

setup unless you change the speaker configuration.

Selecting the speaker configuration

Press SP SEL button repeatedly to select the number of

channels for the SPEAKERS A system.

When the button is pressed, the current speaker setup will be

displayed for about 5 seconds. If you want to change it, press the

same button again within the 5 seconds.

When the button is pressed repeatedly, the number of channels

changes as follows:

Setting the subwoofer mode

Press SW MODE button repeatedly to select the

subwoofer mode.

When the button is pressed, the current subwoofer mode will be

displayed for about 5 seconds. If you want to change it, press the

same button again within the 5 seconds.

When the button is pressed repeatedly, the subwoofer mode

changes as follows:

Note:

When the subwoofer mode is set to MODE 2 and audio is

reproduced in the STEREO mode, the subwoofer may not output

audio from certain sources (2 channel-Dolby Digital/DTS source

etc.).

Adjusting each speaker’s relative volume

balance (Remote controller only)

Adjust each speaker’s relative volume balance so that the volume

of all speaker’s test tones sound equal at the listening position.

1. Press the TEST TONE button.

Adjust the volume by gently increasing it with the VOLUME

5 button. Each speaker produces the test tone (pink noise) in

the following order:

2. To adjust the level of each speaker, press the

CH SEL button to select a speaker and press the

LEVEL 5/∞ buttons to raise or lower the level.

The test tone should sound at the same level when you hear it

in your listening position. You can adjust the level in the range

between –12 dB to +12 dB.

3. Press the TEST TONE button to complete

adjustment.

Front left and right speakers

Front left, right, and center speakers

Front left and right, plus surround

left and right speakers

Front left, right, and center, plus

surround left and right speakers

When small-with limited bass signal

handling-front speakers are connected

When large-wideband-front speakers

are connected

When no subwoofer is connected

Front left speaker

Center speaker

Front right speaker

Surround right speaker

Surround left speaker

Subwoofer

STANDBY/ON

OFF

POWER

PHONES

MASTER VOLUME

BASS

TREBLE

RECEIVER

494

PHONO

TAPE

VIDEO

DVD

ABSPEAKERS

DIMMER

SURROUND

DTS/

VIDEO

VCR

AUDIO

SELECTOR

LISTENING MODE

DSP

STEREO

DISPLAY

STANDBY

SP SEL TUNING PRESET

MEMORY

MODE

DIGITAL

INPUT

MODE

CLEAR

INPUT SELECTOR

MODE

SLEEP DIMMER DISPLAY

CD TAPE PHONO TUNER

D V D VIDEO 1 VIDEO 2

SUR MODE

SW MODE AUDIO SEL

TUNER

PRESET

STANDBY/ ON

DISC

MUTING

DVD CD TAPE

VOLUME

TOP MENU

CH SEL

RETURN

SETUP

TEST TONE

LEVEL

ENTER

SP SEL

TEST TONE

CH SEL

SW MODE

LEVEL 5/∞

SW MODE

VOLUME 5/∞

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo TX-DS494 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo TX-DS494

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info