553752
15
Zoom out
Zoom in
Vorherige Seite
1/52
Nächste Seite
15
Connecting a subwoofer
Use the PRE OUT SUBWOOFER jack to connect a subwoofer with
a built-in power amplifier. If your subwoofer does not have a built-in
amplifier, connect an amplifier to the PRE OUT SUBWOOFER jack
and the subwoofer to the amplifier.
Connecting the speaker cable
1. Strip away 5/8 inch (15 mm) of wire insulation.
2. Twist wire ends very tight.
3. Unscrew
4. Insert wire
5. Screw
Connecting speakers
15mm
(5/8")
12345
FM
75
AM
ANTENNA
REMOTE
CONTROL
MONITOR
OUT
DVD
VIDEO
3
VIDEO
2
VIDEO
1
IN
OUT
IN
IN
IN
VIDEO
S
VIDEO
L
R
OUT
IN
TAPE
PHONO
CD
L
R
GND
CENTER
SUB
WOOFER
FRONT
SURR
SUBWOOFER
PRE OUT
MULTI
CHANNEL INPUT
L
R
OPTICAL
COAXIAL
1
2
12
DIGITAL
INPUT
AV RECEIVER
MODEL NO.
TX-DS595
FRONT
SPEAKERS
B
CAUTION
:
SEE INSTRUCTION MANUAL
FOR CORRECT SETTING.
R
L
6 OHMS
MIN.
/
SPEAKER
4 OHMS
MIN.
/
SPEAKER
IMPEDANCE SELECTOR
AC OUTLETS
SURROUND
SPEAKERS
FRONT
SPEAKERS
A
CENTER
SPEAKER
R
L
SET BEFORE POWER ON
AC 230-240
V 50
Hz
SWITCHED
TOTAL 100W MAX.
R
L
R
L
Center
speaker
Front left
speaker A
Front right
speaker A
Surround
left
speaker
Surround
right
speaker
Subwoofer
Front left
speaker B
Front right
speaker B
NO!
Connecting speakers
1. Check the impedance of the speakers you are
connecting.
The TX-DS595 requires speakers with an impedance of 4 or
greater. Connecting speakers with an impedance of less than 4
may damage the TX-DS595.
2. Set the IMPEDANCE SELECTOR switch according to
the impedance of the speakers being connected.
If all speakers have an impedance of 6 or greater, slide the
IMPEDANCE SELECTOR switch to the left (6 OHMS MIN./
SPEAKER). If one or more speakers have an impedance of less
than 6 , slide the IMPEDANCE SELECTOR switch to the
right (4 OHMS MIN./SPEAKER).
When you are using only one
speaker or when you wish to
listen to monaural (mono)
sound, a single speaker should
never be connected in parallel to
both the right and left-channel
terminals simultaneously.
To prevent damage to circuitry,
never short-circuit the positive
(+) and negative () speaker
wire.
Notes:
The power to the TX-DS595 must not be turned on when
changing the IMPEDANCE SELECTOR setting.
6 OHMS
MIN.
/
SPEAKER
4 OHMS
MIN.
/
SPEAKER
IMPEDANCE SELECTOR
SET BEFORE POWER ON
6 OHMS
MIN.
/
SPEAKER
4 OHMS
MIN.
/
SPEAKER
IMPEDANCE SELECTOR
SET BEFORE POWER ON
4 or above/speaker 6 or above/speaker
NO!
+ ––++––+
RL RL
Be sure to connect the positive and negative cables for the
speakers properly. If they are mixed up, the left and right signals
will be reversed and the audio will sound unnatural.
Do not connect more than one speaker cable to one speaker
terminal. Doing so may damage the TX-DS595.
Use FRONT SPEAKERS B terminals to connect a second pair
of front speakers.
When you listen to surround audio or select Multichannel, be
sure to turn on SPEAKERS A.
15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Onkyo TX-DS595 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Onkyo TX-DS595

Onkyo TX-DS595 Bedienungsanleitung - Französisch - 52 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info