Bedienungsanleitung Onkyo TX-NR579 (Seite 65 von 84) (Englisch)

462088

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

Appendix

Troubleshooting

If you have any trouble using the AV receiver, look for a

solution in this section. If you can’t resolve the issue

yourself, contact your Onkyo dealer.

■ Can’t turn on the AV receiver

■ The AV receiver turns off unexpectedly

■ When the power is restored after a power

interruption, “CHECK SP WIRE” appears on the

display

■ There’s no sound, or it’s very quiet

If you can’t resolve the issue yourself, try resetting the

AV receiver before contacting your Onkyo dealer.

To reset the AV receiver to its factory defaults, turn

it on and, while holding down VCR/DVR, press

8ON/STANDBY. “Clear” will appear on the display

and the AV receiver will enter standby mode.

Note that resetting the AV receiver will delete your

radio presets and custom settings.

To reset the remote controller to its factory defaults,

while holding down RECEIVER, press and hold down

HOME until the remote indicator lights (about 3

seconds). Within 30 seconds, press RECEIVER

again.

The on-screen setup menus appear only on a TV that

is connected to the HDMI OUT. If your TV is

connected to the MONITOR OUT V or the

COMPONENT VIDEO OUT, use the AV receiver’s

display when changing settings.

Power

Make sure that the power cord is properly plugged

into the wall outlet.

—

Unplug the power cord from the wall outlet, wait

five seconds or more, then plug it in again.

—

The AV receiver will automatically enter standby

mode when Auto Standby has been set and launches.

HOME

RECEIVER

Remote indicator

The protection circuit has been activated. Remove

the power cord from the wall outlet immediately.

Disconnect all speaker cables and input sources, and

leave the AV receiver with its power cord

disconnected for 1 hour. After that, reconnect the

power cord and set the volume to maximum. If the

AV receiver stays on, set the volume to minimum,

disconnect the power cord, and reconnect your

speakers and input sources. If the AV receiver turns

off when you set the volume to maximum,

disconnect the power cord, and contact your Onkyo

dealer.

—

Audio

Make sure that the digital input source is selected

properly.

Make sure that all audio connecting plugs are pushed

in all the way.

Make sure that the inputs and outputs of all

components are connected properly.

15-18

Make sure that the polarity of the speaker cables is

correct, and that the bare wires are in contact with

the metal part of each speaker terminal.

Make sure that the input source is properly selected. 21

Make sure that the speaker cables are not shorting. 12

Check the volume. The AV receiver is designed for

home theater enjoyment. It has a wide volume range,

allowing precise adjustment.

—

If the MUTING indicator is flashing on the display,

press the remote controller’s MUTING to unmute

the AV receiver.

While a pair of headphones is connected to the

PHONES jack, no sound is output from the

speakers.

If there’s no sound from a DVD player connected to

an HDMI IN, check the DVD player’s output

settings, and be sure to select a supported audio

format.

—

Check the digital audio output setting on the

connected device. On some game consoles, such as

those that support DVD, the default setting is off.

—

With some DVD-Video discs, you need to select an

audio output format from a menu.

—

If your turntable uses an MC cartridge, you must

connect an MC head amp, or an MC transformer.

—

Make sure that none of the connecting cables are

bent, twisted, or damaged.

—

Not all listening modes use all speakers. 33

Specify the speaker distances and adjust the

individual speaker levels.

Make sure that the speaker setup microphone is not

still connected.

—

The input signal format is set to “PCM” or “DTS”.

Set it to “Off”.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo TX-NR579 Seite 65

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo TX-NR579

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info