Bedienungsanleitung Parkside IAN 311314 PGI 1200 A1 (Seite 10 von 48) (Deutsch, Englisch, Holländisch, Französisch)

749335

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

5GB/IE/NI

Engine oil 0.25 l

(15W-40)

Use at ⅔ engine load approx. 0.88 l/h

Weight 12.8 kg

Sound pressure level LpA 74.39 dB (A)

Sound power level LWA 95 dB(A)

Uncertainty K 1.07 dB (A)

Power factor cos ϕ 1

Performance class G1

Quality class B

Spark plug MS A7RTC

Operating mode S1 (long use)

The machine can be used continuously with the indicated

power.

Operating mode S2 (Short term use)

The machine can be used in the short term with the indicated

power.

Acceptable ambient temperature:

-10 to +40 °C

Height: 1000 m above NN

rel. air humidity: 90 % (not condensed)

7. Before starting the equipment

• Open the packaging and remove the device carefully.

• Remove the packaging material as well as the packaging

and transport bracing (if available).

• Check that the delivery is complete.

• Check the device and accessory parts for transport dam-

age.

• If possible, store the packaging until the warranty period

has expired.

ATTENTION

The device and packaging materials are not toys!

Children must not be allowed to play with plastic

bags, ﬁlm and small parts! There is a risk of swal-

lowing and suﬀocation!

Installation (Fig. 1/2)

To attach the handle (1), remove both Phillips screws M6x35

mm which are inserted. Place the handle (1) in position and

screw it tight. Attach all parts before pouring in fuel or oil in

order to prevent leaking of liquids.

Electrical safety

Prior to use, the generator and its electrical equipment (includ-

ing lines and plug connectors) should be checked to ensure

that there are no defects.

Never connect the generator to the mains (power point).

Keep the cables as short as possible.

Earthing (Fig. 1)

Earthing is needed to disperse static discharge. Connect a ca-

ble from one side of the earthing connector (7) of the generator

and from the other side to an external ground.

ATTENTION! When being used for the ﬁrst time, motor oil

(15W-40, approx. 0.25 l) and petrol (unleaded normal petrol)

must be put in.

Check the fuel level and the oil, and if necessary top them

up. Make sure you have adequate ventilation. Ensure that the

spark cable is securely in the spark plug. Unplug any electric

device connected to the generator.

Putting in oil (Fig. 5)

Put the generator with its front side down and unscrew the oil

ﬁller plug (13). Pour in 0.25 litres of engine oil (15W-40).

Close the oil ﬁller cap (13) and stand the generator upright

Putting in fuel (Fig. 1/7)

Keep away from ignition sources! Always refuel in well-ventilat-

ed rooms or outside. Open the fuel tank cap (2) and, using a

ﬁller pipe (not included in delivery), pour in a maximum of 4.2

litres of unleaded fuel into the fuel container. Ensure the tank

level is not exceeded and no fuel is spilled. Use the fuel ﬁlter.

Clean up spilled fuel immediately and wait until the fuel fumes

have evaporated (ﬁre hazard). Close the fuel tank cap (2).

8. Operation

Start the engine (Fig. 1/3/6)

ATTENTION! When starting with the express start (10) you

can injure your hand with the sudden kick back.

Wear protective gloves when starting.

• Open the petrol tap (17) by turning the tap downwards.

• Put the on / oﬀ switch (6) to the “on” position. Turn the choke

lever (9) to I I (in the left position).

• Start the engine with the express start (10) by sharply pull-

ing the handle. If the engine has not started pull the handle

again.

• Push the choke lever (9) back once the engine has started

(in the right position).

• Connect the device to the 230 V∼ socket (8).

ATTENTION! This socket can be loaded continuously (S1)

with 1000 W and short term (S2) for a maximum of 5 seconds

with 1200 W.

Note: Some electric devices (sabre saws, drills etc.) can use

more electricity when doing heavy duty tasks.

Storing the engine (Fig. 1/6)

Before putting away, let the generator run without load so that

the device can „cool down“.

• Turn the on / oﬀ switch to the „OFF“ position.

• Close the petrol tap.

Overload protection 230 V∼ socket

NOTE! This generator is ﬁtted with an overload protector.

This cuts oﬀ the sockets.

Green operating bulb:

Flashes 1 x per interval Speed too low

Flashes 2 x per interval Temperature too high

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Parkside IAN 311314 PGI 1200 A1 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info