Bedienungsanleitung Philips cc 5060 17 (Seite 3 von 9) (Deutsch, Englisch, Holländisch, Französisch)

401659

Zoom out

Zoom in

Vorherige Seite

1/9

Nächste Seite

2 Press and hold the setting selector (1) with one

hand and pull the comb off the appliance (2) with

your other hand (Fig. 8).

Never pull at the exible top of the comb. Always pull at

the bottom part.

3 Push the middle part of the cutting unit upwards

with your thumb until it opens (Fig. 9).

4 Clean the cutting unit with the cleaning brush

supplied (Fig. 10).

5 Clean the inside of the appliance with the cleaning

brush supplied (Fig. 11).

6 Close the cutting unit (‘click’).

Replacement

Only replace a damaged or worn cutting unit with an

original Philips cutting unit.

1 Push the middle part of the cutting unit upwards

with your thumb until it opens and then pull it off

the appliance (Fig. 9).

2 Place the lug of the new cutting unit into the

slot and push the cutting unit onto the appliance

(‘click’).

Accessories

The following accessories are available:

HQ8500 adapter

Large comb

Small comb

Cutting element

Environment

Do not throw away the appliance with the normal

household waste at the end of its life, but hand it in

at an ofcial collection point for recycling. By doing

this, you help to preserve the environment (Fig. 12).

The built-in rechargeable battery contains substances

that may pollute the environment. Always remove

the battery before you discard and hand in the

appliance at an ofcial collection point. Dispose of

the battery at an ofcial collection point for batteries.

If you have trouble removing the battery, you can

also take the appliance to a Philips service centre.

The staff of this centre will remove the battery for

you and will dispose of it in an environmentally safe

way. (Fig. 13)

Removing the rechargeable battery

Only remove the rechargeable battery if it is completely

empty.

1 Disconnect the appliance from the mains and let

the appliance run until the motor stops.

2 Push the middle part of the cutting unit upwards

with your thumb until it opens (Fig. 9).

3 Undo the two screws in the hair chamber (Fig. 14).

4 Use both hands to separate the front part of the

housing from the back part and remove the front

part of the housing (Fig. 15).

5 Undo the 4 screws next to the battery. (Fig. 16)

6 Remove the bumper (Fig. 17).

7 Undo the 2 screws of the socket at the bottom of

the appliance (Fig. 18).

8 Remove the socket from the appliance (Fig. 19).

9 Lift the rechargeable battery and the printed circuit

board out of the appliance and cut the connecting

wires (Fig. 20).

Do not connect the appliance to the mains again after

you have opened it.

Guarantee & service

If you need service or information or if you have a

problem, please visit the Philips website at www.philips.

com or contact the Philips Consumer Care Centre

in your country (you nd its phone number in the

worldwide guarantee leaet). If there is no Consumer

Care Centre in your country, go to your local Philips

dealer.

4222.002.8043.1

3/9

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips cc 5060 17 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info