Bedienungsanleitung Philips FT565 (Seite 6 von 44) (Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

799038

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

• Press button ® 'DOWN' or @ 'UP' repeatedly

and briefly. This changes the tuning frequency step

by step until the correct value is reached. If it is a

stereo transmission indicator @ 'STEREO' lights

up.

Note:

With powerful transmitters the 'TUNED'

indicator lights up. This does not happen wIth

relatlvely weal< transmitters. In these cases press

button d) or @ briefiy again, until reception is

optimum.

If you pass the required frequency

Go back step by step to the desired frequency by

briefly and repeatedly pressing the ether button

@or

(8).

• Depress, if desired, key @ 'FM-NR' to reduce

posslble noise.

• During tuning the audio signals are completely

suppressed to prevent any interference trom

parasitic nolse.

• If you are tuning to weak FM transmitters, press

button @ 'FM AUTO STEREO' once; indicator ®

'FM auto stereo' goes out. The tuner then only piays

back in mono and the audio signal is not suppres-

sed during tuning; this prevents these transmitters

from being suppressed.

C. Tuning to pre-selected transmitters

Pre-selected transmitters can only be tuned If they

have been programmed beforehand in the memory.

Programming transmitters

• Tune either automatically or manually to the

transmitter to be programmed.

• Press button @ 'MEMORY'. Indicator

'MEMORY' lights up on display @.

• Then while Indicator 'MEMORY' is llt up (5 se-

conds),

quickly press the required pre-selected

location @ 'PRESET STATION'. To programme one

of the locations 1 to 8, press the required button

briefiy (less than 0.5 second). (FM, LW or MW

transmitters).

To programme one of the locations 9 to 16 press

the required button (jonger than 0.5 second). (FM

transmitters only). WhIle programming, pay at-

tentlon to display 0.

Wofe;Two FM, 1 medium or 1 long wave transmitter

can be programmed by button 0. By the use of FM

transmitters, mono and stereo can be program-

med.

• The tuner has a standby functlon which prevents

the loss of Information stored In the memory tor a

period of 7 days In the event of a power cut. If the

Interruption lasts for longer than 7 days, the trans-

mitters must be reprogrammed.

Calling up stored transmitters

• Select the required tuning range with selector

button @ 'LW', @ 'MW' or @ 'FM'.

• Press the required pre-seiected location 0

'PRESET STATION'.

With FM press briefly for the pre-selected locations

1 to 8 and slightly longer for the pre-selected

locations 9 to 16. With LW and MW the length of

time the button is pressed has no influence. Pay

attentlon to display 0.

• Depress, If desired, key @ 'FM-NR' to reduce

posslble nolse.

• It is posslble to change from this pre-selected

tuning to manual or automatic tuning without further

actlon.

• A pre-selected transmitter can only be retrieved

from the memory by programming another In place

of It.

GENERAL INFORMATION

Signal suppression (mute)

The audio signal disappears (mute) during varlous

operations. The purpose of this is to suppress any

Interference from parasitic noise. It occurs for

example during automatic tuning (tuning cracklel),

when operating buttons 0 'DOWN' and 0 'UP'.

FM stereo playback

Powerful FM stereo signals are reproduced nolse-

free by the tuner. Indicator @ 'STEREO' then lights

up.

With weaker signals the nolse level quickly In-

creases. This noise can be reduced by depressing

key @ 'FM-NR' but from a certain limit It Is

recommended to switch over to mono playback.

First switch off nolse reduction key @ 'FM-NR' and

depress key @ 'FM AUTO STEREO' once. Indicator

0 'FM auto stereo' then goes out.

Service

The outside of the tuner can be cleaned with a damp

fiuff-free cloth. Use only water to dampen the cloth.

TECHNICAL DATA

(subject

to modification)

FM section

• Wave range:

87,5-108

MHz

• Sensltlvity at 75 ohm:

mono, 26 dB S/N: 1.3 nV at 75 kHz devlatlon

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips FT565 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info