Bedienungsanleitung Pioneer VSX-1019AH-K (Seite 105 von 128) (Englisch)

455217

105

Zoom out

Zoom in

Vorherige Seite

1/128

Nächste Seite

Additional information 12

105

Other audio problems

Symptom Remedy

Broadcast stations cannot be

selected automatically, or

there is considerable noise in

radio broadcasts.

For FM broadcasts

• Fully extend the FM wire antenna, adjust the position for best reception and

secure to a wall, etc.

• Use an outdoor antenna for better reception (see page 30).

For AM broadcasts

• Adjust the position and direction of the AM antenna.

• Use an outdoor antenna for better reception (see page 30).

• Noise may be caused by interference from other equipment, such as a

fluorescent light, motor, etc. Switch off or move the other equipment, or move

the AM antenna.

A multichannel DVD source

appears to be downmixed to

2 channels during playback.

• Make sure that the multichannel analog inputs are selected (see Selecting the

multichannel analog inputs on page 42).

Noise is output when

scanning a DTS CD.

• This is not a malfunction of the receiver. The scan function of your player

alters the digital information, making it unreadable, resulting in noise being

output. Lower the volume when scanning.

When playing a DTS format

LD there is audible noise on

the soundtrack.

• Make sure that the input signal type is set to DIGITAL (see Choosing the input

signal on page 58).

Can’t record audio. • You can only make a digital recording from a digital source, and an analog

recording from an analog source.

• For digital sources, make sure that what you’re recording isn’t copy protected.

• Check that the OUT jacks are properly connected to the recorders input jacks

(see Connecting other audio components on page 29).

Subwoofer output is very low. • To route more signal to the subwoofer, set it to PLUS or set the front speakers

to SMALL (see Speaker Setting on page 95).

Everything seems to be set up

correctly, but the playback

sound is odd.

• The speakers may be out of phase. Check that the positive/negative speaker

terminals on the receiver are matched with the corresponding terminals on the

speakers (see Connecting the speakers on page 18).

The PHASE CONTROL

feature doesn’t seem to have

an audible effect.

• If applicable, check that the lowpass filter switch on your subwoofer is off, or

the lowpass cutoff is set to the highest frequency setting. If there is a PHASE

setting on your subwoofer, set it to 0º (or depending on the subwoofer, the

setting where you think it has the best overall effect on the sound).

• Make sure the speaker distance setting is correct for all speakers (see Speaker

Distance on page 97).

Noise or hum can be heard

even when there is no sound

being input.

• Check that personal computers or other digital components connected to the

same power source are not causing interference.

There seems to be a time lag

between the speakers and

the output of the subwoofer.

• See Automatically setting up for surround sound (Auto MCACC) on page 37 to

set up your system again using MCACC (this will automatically compensate for

a delay in the subwoofer output).

The maximum volume

available (shown in the fr ont

panel display) is lower than

the +12dB maximum.

• Check that the Volume Limit is set to OFF (see Volume Limit Setup on

page 100).

VSX-1019_KU.book 105 ページ２００９年２月１７日　火曜日　午前１１時５６分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer VSX-1019AH-K Seite 105

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer VSX-1019AH-K

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info