Bedienungsanleitung Quadra-Fire Classic Bay 1200 - Pellet

815525

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

19 04/217027-805J

Clinker

Figure 19.1

Back side of Firepot

Firepot floor left open

Figure 19.2

NOTE: If you are just cleaning the re pot, there is no

need to unplug the insert.

C. General Maintenance and Cleaning

1. Types of Fuel

Type of fuel you are burning will dictate how often you have

to clean your re pot.

If the fuel you are burning has a high dirt or ash content, it

may be necessary to clean the re pot more than once a

day.

Dirty fuel will cause clinkers to form in the re pot

(Figure 19.1). A clinker is formed when dirt, ash or a non-

burnable substance is heated to 2000°F (1093°C) and

becomes glass-like. High Ash Fuel Content Maintenance

on page 23 in this section for more details on fuels with high

ash content.

3. Ash Removal from Firebox

• Frequency: Weekly or more frequently depending on

ash build-up

• By: Homeowner

a. There must not be any hot ashes in the rebox during

cleaning so allow the appliance to completely cool.

Frequent cleaning of the ash in the rebox will help

slow down the build-up of ash in the exhaust blower

and vent system.

b. Plug in your appliance, if unplugged, and turn the

thermostat on and immediately shut it o󰀨 to start the

exhaust blower on its cycle time. It will pull y ash out

the exhaust instead of into the room.

c. Open door. There are 2 cleaning slide plates to the

left and right of the re pot with nger holes. Pull both

slide plates out and sweep the remaining ash from

the rebox into the 2 open holes. A paint brush works

well for this. Close slide plates.

d. This ash is deposited in the same ash drawer as the

re pot debris. The ash drawer should be emptied

every time you clean the rebox. Remember to

place the ash and debris into a metal or non-

combustible container.

e. The 2 cleaning slide plates must be fully closed when

cleaning is complete. See Disposal of Ashes on

page 20.

4. Cleaning Ash Drawer

• Frequency: Weekly or every 5 bags of fuel

• By: Homeowner

Empty into a non-combustible container and re-install ash

drawer (Disposal of Ashes on page 20).

b. Pull re pot cleaning rod OUT and IN a couple of

times to help shake debris loose.

c. If rod is hard to pull, it may be necessary to use your

re pot clean-out tool to chip away material that has

built up on the bottom plate of the re pot and to

push out any clinkers. Larger clinkers may have to be

removed from the top of the re pot.

d. The re pot oor plate must be fully closed when

nished (Figure 19.2).

2. Cleaning Fire pot with Cleaning Rod & Fire pot

Clean-Out Tool

• Frequency: Daily or more often as needed

• By: Homeowner

a. The appliance must be in complete shutdown and

cool and the exhaust blower o󰀨.

Fire Risk.

• NEVER pull re pot cleaning rods or

cleaning slide plates when appliance is

operating. Hot pellets may fall into ash pan

and may start a re or have mis-starts due

to lack of vacuum.

WARNING

Fire Risk

• The cleaning slide plates must be fully

CLOSED when appliance is operating.

Hot pellets may fall into ash pan and start

a re.

WARNING

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Quadra-Fire Classic Bay 1200 - Pellet - Insert Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Quadra-Fire Classic Bay 1200 - Pellet - Insert

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info